Cisco
200-301 · Question #1087
Refer to the exhibit. Routers R1, R2, and R3 use a protocol to identify the neighbors' IP addresses, hardware platforms, and software versions. A network engineer must configure R2 to avoid sharing an
The correct answer is C. Configure the no cdp enable command on g0/2.. We need to disable CDP only on the interface to R3, while still allowing it globally.
Submitted by klara.se· Mar 5, 2026Network Fundamentals
Question
Refer to the exhibit. Routers R1, R2, and R3 use a protocol to identify the neighbors' IP addresses, hardware platforms, and software versions. A network engineer must configure R2 to avoid sharing any neighbor information with R3, and maintain its relationship with R1. What action meets this requirement?
Options
- AConfigure the no lldp receive command on g0/1.
- BConfigure the no cdp run command globally.
- CConfigure the no cdp enable command on g0/2.
- DConfigure the no lldp run command globally.
How the community answered
(40 responses)- A13% (5)
- B3% (1)
- C80% (32)
- D5% (2)
Explanation
We need to disable CDP only on the interface to R3, while still allowing it globally.
Topics
#CDP#Neighbor Discovery#Interface Configuration
Community Discussion
No community discussion yet for this question.