Which requirement does the ICT distribution designer provide to the Mechanical Engineer in charge of the HVAC design for a Telecommunication Space?

Question

Options

• AThe heat load (BTU (calories/hour) of all equipment installed within the space
• BLocation of the telecommunications own dedicated electrical distribution panel
• CThe quantity and size of HVAC vents needed for the room
• DLocation and size of condensate drain

• A
  80% (33)
• B
  5% (2)
• C
  12% (5)
• D
  2% (1)

Explanation

Option A is correct because the ICT distribution designer's primary responsibility to the HVAC engineer is communicating the heat load generated by all telecommunications equipment - this is the foundational input the mechanical engineer needs to size and design the HVAC system appropriately for the space. Without accurate BTU data, the HVAC system cannot be properly specified.

• B is wrong because the electrical distribution panel location is provided to the electrical engineer, not the HVAC/mechanical engineer - it's outside HVAC scope.
• C is wrong because the quantity and size of HVAC vents is an output of the mechanical engineer's design process, not an input they receive from the ICT designer.
• D is wrong because condensate drain location/size is determined by the HVAC engineer based on their own equipment design, not dictated by the ICT distribution designer.

Memory tip: Think of it as "heat in, air out" - the ICT designer only inputs heat load data (what the equipment generates), and the mechanical engineer handles everything else output-related (vents, drains, sizing). The ICT designer doesn't design HVAC components; they just report how hot their equipment runs.

No community discussion yet for this question.