Which of the following is a consideration for lighting telecommunication spaces?

Question

Options

• ATo ensure worker safety within TEs. Light level requirements are higher tor these than other
• BThe light fixtures within telecommunications spaces shall be fluorescent type fixtures.
• CThe electrical power for lighting shall be connected to the same electrical panel as the
• DThe lighting layout shall be coordinated with the equipment and pathway locations

• A
  11% (7)
• B
  5% (3)
• C
  3% (2)
• D
  82% (53)

Explanation

Option D is correct because telecommunications spaces contain racks, cabinets, cable pathways, and equipment that must remain accessible and visible to technicians. Lighting layout must be planned around where equipment will be installed - fixtures placed directly above racks or pathways ensure adequate illumination where work actually occurs, rather than creating dark spots behind or between equipment.

Why the distractors are wrong:

• A is incorrect because telecommunications spaces (TEs) do not have higher light level requirements than general work areas - standard foot-candle requirements apply, and worker safety is achieved through proper layout (which D addresses), not elevated levels.
• B is incorrect because the standards (such as BICSI and TIA-569) do not mandate fluorescent fixtures specifically; LED and other fixture types are acceptable, provided they meet illumination requirements.
• C is incorrect and actually describes a practice to avoid - lighting circuits should be on a separate electrical panel from telecom equipment to prevent interference and ensure lights stay on even during equipment power events.

Memory tip: Think "light follows layout" - in telecom spaces, you always design lighting after you know where the equipment and pathways go, so nothing ends up in the dark. If a choice says lighting must match a specific fixture type or be on the same panel as equipment, that's a red flag.

No community discussion yet for this question.