MTCNA Exam Questions
230 real MTCNA exam questions with expert-verified answers and explanations. Page 2 of 5.
- Question #51
What PPP protocol provides dynamic addressing, authentication, and multilink?
- Question #52
Simple Queue number 0 defines 2M for upload and download for target IP 10.10.0.33. Simple Queue number 1 defines 4M for upload and download for target IP 10.10.0.33. Client 10.10.0...
- Question #53
Select valid MACaddress
- Question #54
DHCP server is configured on a router's ether1 interface. IP address 192.168.0.100/24 is assigned to the interface. Possible IP pools, that can be used by this DHCP server, are:
- Question #55
Consider the following network diagram. In R1, you have the following configuration: /ip route add dst-address=192.168.1.0/24 gateway=192.168.99.2 /ip firewall nat add chain=srcnat...
- Question #56
What protocol is used to find the hardware address of a local device?
- Question #57
Select valid MAC-address
- Question #58
What is the default TTL (time to live) on a router that an IP packet can experience before it will be discarded?
- Question #59
The correct order for PPPOE discovery stage is
- Question #60
If you wanted to delete the configuration stored in NVRAM, what would you type?
- Question #61
In order to use dynamic keys in your wireless security profile for an AP, you MUST set up the dhcp server to provide the dynamic keys.
- Question #62
What does a VLAN do?
- Question #63
One host on an internal network is accessing an external web page through a MikroTik router that is doing source NAT. Select correct statement about the packets that flow from that...
- Question #64
For static routing functionality, additionally to the RouterOS 'system' package, you will also need the following software package:
- Question #65
What protocols are used to configure trunking on a switch? 1. VLAN Trunking Protocol 2. VLAN 3. 802.1Q 4. ISL
- Question #66
To block communications between wireless clients connected to the same access point interface, you should set
- Question #67
Which of the following Routes statuses are possible?
- Question #68
Consider a wireless access point with mode=ap-bridge. What is the maximum number of concurrent clients that can connect to it?
- Question #69
Mark all correct answers.
- Question #70
From which of the following locations can you obtain Winbox?
- Question #71
Destination NAT (chain dstnat, action dst-nat) can be used to:
- Question #72
You want to implement a mechanism that automates the IP configuration, including IP address, subnet mask, default gateway, and DNS information. Which protocol will you use to accom...
- Question #73
What is the meaning of letter "R" on an active session in the menu PPP Active Connections?
- Question #74
How many layers does Open Systems Interconnection model have?
- Question #75
What layer in the TCP/IP stack is equivalent to the Transport layer of the OSI model?
- Question #76
The network address is
- Question #77
Which of the following are TCP/IP protocols used at the Application layer of the OSI model? 1. IP 2. TCP 3. Telnet 4. FTP 5. TFTP
- Question #78
If ARP=reply-only is configured on an interface, this interface will
- Question #79
What is the correct action for a NAT rule on a router that should intercept SMTP traffic and send it over to a specified mail server?
- Question #80
Select all tunnels that support authentication of clients with a username and password.
- Question #81
What menus should be used to allow certain websites to be accessed from behind a Hot-Spot interface, without client authentication
- Question #82
Mark all packages required for PPPoE server on MikroTik RouterOS
- Question #83
In RouterOS queue configurations the word "total" ussually represents
- Question #84
Which of the following allows a router to respond to an ARP request that is intended for a remote host?
- Question #85
In a network with dozens of switches, how many root bridges would you have?
- Question #86
A DHCP server is configured on a LAN interface which is a port on a bridge. The DHCP server does not start. What could be the reason(s)?
- Question #87
How many DHCP servers can be configured per interface on RouterOS?
- Question #88
For a Simple Queue to apply a bandwidth restrictions on a bridged interface, following must be done:
- Question #89
Why is it useful to set a Radio Name on the radio interface?
- Question #90
When viewing the routes in Winbox, some routes will show "DAC" in the first column. These flags mean:
- Question #91
What is the correct action to be specified in the NAT rule to hide a private network when communicating to the outside world?
- Question #92
To connect your MikroTik router to a wireless access point, you have to:
- Question #93
What can be used as 'target-address' in the simple queue?
- Question #94
How many wireless clients can connect, when wireless card is configured to mode=bridge?
- Question #95
Select which of the following are 'Public IP addresses':
- Question #96
What does the firewall action "log" do?
- Question #97
What letters appear next to a route, which is automatically created by RouterOS when user adds a valid address to an active interface?
- Question #98
Select valid subnet masks:
- Question #99
During a scan, in order to see all the available wireless frequencies that are supported by the card, the following option must be selected in the wireless card's "Frequency Mode":
- Question #100
How many IP addresses can one find in the header of an IP packet?