MTCNA Exam Questions

What is the default protocol/port of (secure) winbox?

What does the passive command provide to dynamic routing protocols?

Is it possible to limit how many clients are able to connect to an access point?

It is possible to create an encrypted PPPoE tunnel in RouterOS:

For user in local PPP Secrets/PPP Profiles database, it is possible to

Which of the following is the valid host range for the subnet on which the IP address 192.168.168.188 255.255.255.192 resides?

Firewall NAT rules process only the first packet of each connection.

Which of these are possible solutions to bridge two networks over a wireless link:

To back up an IOS, what command will you use?

Which of the following are layers in the TCP/IP model? 1. Application 2. Session 3. Transport 4. Internet 5. Data Link 6. Physical

Which is a default baud-rate of currently manufactured RouterBOARDs?

What is term for the hardware coded address found on an interface?

Which class of IP address has the most host addresses available by default?

What kind of users are listed in the Secrets window of the PPP menu?

What command is used to create a backup configuration?

Which of the following services use UDP? 1. DHCP 2. SMTP 3. SNMP 4. FTP 5. HTTP 6. TFTP

Evaluate the following information: Access Point configuration: -- wlan1 is in 'AP-Bridge' mode -- Bridge1 has wlan1 and ether1 as ports CPE configuration: -- wlan1 is in 'Station-...

Which firewall chain should you use to filter clients HTTP traffic going through the router?

Which one of the following is true regarding VLANs?

Collisions are possible in fullduplex Ethernet networks

You have a DHCP server on your MikroTik router. The IP addresses 10.1.2.2-10.2.2.20 are distributed in the DHCP network. Additionally, 3 static IP address are defined for your serv...

What does this simple queue do (check the image)?

If you use either Telnet or FTP, which is the highest layer you are using to transmit data?

Which class of IP address provides a maximum of only 254 host addresses per network ID?

There are two wireless cards (wlan1 and wlan2) which are bridged together. On wlan1 card there is a setting "Forwarding=no". Choose the correct answer(s):

PPP Secrets are used for

What is possible with Netinstall?

Which features are removed when advanced-tools package is uninstalled?

In which order are the entries in Access List and Connect List processed?

Please select valid scan-list values in interface wireless configuration:

It is possible to create a configuration where VLAN and PPTP interfaces are bridged together.

Which protocol does DHCP use at the Transport layer?

How many collision domains are created when you segment a network with a 12-port switch?

Which of the following is used in standard 802.11 wireless networks?

Which type of encryption could be used to establish a connection with a simple passkey without using a 802.1X authentication server?

Which is the default port of IP-Winbox?

Select minimal set of software packages in RouteOS required to configuring a wireless AP

Which command is used to determine if an IP access list is enabled on a particular interface?

Which WLAN IEEE specification allows up to 54Mbps at 2.4GHz?

When adding a static route, you must always ensure that you add both the gateway and the interface.

Which layer 4 protocol is used for a Telnet connection?

A client that has successfully connected to a wireless network is considered to be which of the following? Choose all that apply:

A network ready device is directly connected to a MikroTik Router BOARD 750 with a correct U.T.P. RJ45 functioning cable. The device is configured with an IPv4 address of 192.168.1...

You need to reboot a RouterBoard after importing a previously exported rsc file to activate the new configuration.

Where is a hub specified in the OSI model?

Which port does PPTP use by default?

MikroTik RouterOS commands can be run once a day by:

Action=redirect is applied in

Which of the following is NOT a valid MAC Address?

In which situations can Netinstall NOT be used to install a RouterBOARD?