JN0-696 · Question #36
In preparation for future expansion, a user decides to configure a stand-alone SRX Series device for chassis-clustering mode. The user enters the command set chassis cluster cluster-id 0 node 0…
The correct answer is C. Cluster ID 0 is not valid for a chassis cluster. Cluster-id numbering can range from 1-15. Configuring a cluster-id of 0 is equivalent to disabling chassis cluster. summary/set-chassiscluster-clusterid-node-reboot.html
Question
In preparation for future expansion, a user decides to configure a stand-alone SRX Series device for chassis-clustering mode. The user enters the command set chassis cluster cluster-id 0 node 0 reboot on the device. After the device reboots, the user sees this output:
user@host> show chassis cluster status error: Chassis cluster is not enabled. user@host> The device does not enter chassis-clustering mode. What is the problem?
Options
- AAn SRX Series device will not enter chassis-clustering mode unless the fxp0 and fxp1 interfaces
- BAn SRX Series device will only enter chassis-clustering mode when it finds a peer that is also
- CCluster ID 0 is not valid for a chassis cluster.
- DNode ID 0 is not valid for a chassis cluster.
How the community answered
(27 responses)- A4% (1)
- B7% (2)
- C78% (21)
- D11% (3)
Explanation
Cluster-id numbering can range from 1-15. Configuring a cluster-id of 0 is equivalent to disabling chassis cluster. summary/set-chassiscluster-clusterid-node-reboot.html
Topics
Community Discussion
No community discussion yet for this question.