JN0-348 Exam Questions
222 real JN0-348 exam questions with expert-verified answers and explanations. Page 3 of 5.
- Question #102
The IS-IS adjacency between routers R1 and R2 will not establish. Referring to exhibit, what is the problem?
- Question #103
You are asked to change the default behavior of your trunk port (ge-0/0/1) to now pass untagged traffic. Which configuration would accomplish this task?
- Question #104
Which two statements are true about nonstop bridging (NSB)? (Choose two.)
- Question #107
You received an alert from your monitoring system that the master Routing Engine (RE) on an EX4300 switch in a virtual chassis has hardware issues and might need to be replaced. Be...
- Question #108
Which two statements are true about Virtual Chassis? (Choose two.)
- Question #109
Which two statements are true about the IRB interface? (Choose two.)
- Question #110
You manage the Layer 2 network shown in the exhibit. You experience a failure on the ge- 0/0/0 link between Switch-1 and Switch-2. Which statement is correct about the expected beh...
- Question #111
Referring to the exhibit, which statement explains why the route to 192.168.178.0/24 advertised from 192.168.35.90 is hidden?
- Question #112
What will be two results of the OSPF configuration shown in the exhibit? (Choose two.)
- Question #113
Referring to the exhibit, which two statements are true regarding IS-IS adjacencies? (Choose two.)
- Question #115
Referring to the exhibit, which two statements are correct? (Choose two.)
- Question #116
Which two statements are true about link aggregation groups (LAGs)? (Choose two.)
- Question #117
Referring to the exhibit, a packet tagged with vlan-id 34 arrives on interface xe-0/2/3.0 with a source MAC that does not match an entry in the DHCP snooping database. In this scen...
- Question #118
You have an existing Virtual Chassis consisting of five member devices. Member 3 fails and must be replaced. You remove the EX Series switch with a Member ID of 3 and install a rep...
- Question #119
You are asked to ensure that a designated interface on an EX Series switch only allows a specific server to pass traffic. Which two features are required to satisfy this solution?...
- Question #120
Which statement describes optional transitive BGP attributes?
- Question #121
Which LSA type describes the router ID of ASBR routers located in remote areas?
- Question #122
Which statement is true about load balancing of equal cost paths?
- Question #123
Referring to the exhibit, which three statements are true? (Choose three.)
- Question #124
You have deployed a Juniper EX Series switch in the network. The switch receives a broadcast frame on an interface. Which statement describes the behavior of the switch?
- Question #125
You are troubleshooting an IS-IS adjacency problem as shown in the exhibit. Which action would solve the problem?
- Question #126
There are dynamically and statically routed networks attached to the ge-0/0/1 interface on R1. You only want the dynamically learned routes to show up in routing tables for R2 and...
- Question #127
Referring to the exhibit, which two statement are true? (Choose two.)
- Question #128
Referring to the exhibit, why is the 0.0.0.0/0 route hidden?
- Question #129
You are monitoring your IS-IS router and issue the command shown in the exhibit. Which two statements are true in this scenario? (Choose two.)
- Question #130
Referring to the exhibit, which statement is correct?
- Question #131
What are two terminating actions of a Layer 2 firewall filter? (Choose two.)
- Question #132
You disconnected a switch from the Virtual Chassis, but the disconnected switch's member ID is still displayed in the status output. Which operational command is used to remove the...
- Question #133
There is a GRE tunnel configured over the Internet between Router-1 and Router-2. An OSPF adjacency is configured over this GRE tunnel. However, the OSPF adjacency briefly reaches...
- Question #134
Referring to the exhibit, which path will traffic from R6 take to reach R1?
- Question #135
You are troubleshooting your OSPF configuration and notice that you have subnet mismatch errors when running the show ospf statistics command. Which two actions would further troub...
- Question #136
What are two OSPF packet types that use multicast for communication on a multicast segment? (Choose two.)
- Question #137
Which two statements describe the BGP Local Preference attribute? (Choose two.)
- Question #138
Which three mechanisms are associated with the bridging process? (Choose three.)
- Question #139
Which two OSPF LSA types will you see in a stub area? (Choose two.)
- Question #140
Which two statements describe aggregate routes? (Choose two.)
- Question #141
What are two benefits of 802.3ad link aggregation? (Choose two.)
- Question #142
Which statement is true about IP-IP tunnels?
- Question #143
You have a conference room with an open network port that is used by employees to connect to the network. You are concerned about rogue switches being connected to this port. Which...
- Question #144
Which statement is correct about IS-IS link state PDUs?
- Question #147
Which two characteristics are true for EBGP peerings? (Choose two.)
- Question #148
What are two advantages of a point-to-point OSPF adjacency? (Choose two.)
- Question #149
Which two port security features use the DHCP snooping database for additional port security? (Choose two.)
- Question #150
You want to configure Layer 2 services over an IP-based tunneling mechanism between two sites. Which configuration statement is required to accomplish this task?
- Question #151
Which two routers belong to the 172.16.0.0/22 aggregate route? (Choose two.)
- Question #152
Which two statements are correct regarding the root bridge election process when using STP? (Choose two.)
- Question #153
What are two reasons for configuring more than one VLAN on a switch? (Choose two.)
- Question #154
Referring to the exhibit, which configuration will force traffic to always use ae0.0 as long as it is active?
- Question #155
What are two characteristics of OSPF ABRs? (Choose two.)
- Question #156
Which statement is correct about trunk ports?