Juniper
JN0-348 · Question #118
You have an existing Virtual Chassis consisting of five member devices. Member 3 fails and must be replaced. You remove the EX Series switch with a Member ID of 3 and install a replacement switch in…
The correct answer is B. Recycle the member ID of the switch being replaced. See the full explanation below for the reasoning.
Question
You have an existing Virtual Chassis consisting of five member devices. Member 3 fails and must be replaced. You remove the EX Series switch with a Member ID of 3 and install a replacement switch in its place using identical cabling as shown in the exhibit. The replacement's member ID is 6, so the configuration for member ID 3 is not applied to it. Referring to the exhibit, what should have been done before installing the replacement switch?
Exhibit
Options
- AReactivate the Virtual Chassis.
- BRecycle the member ID of the switch being replaced.
- CRenumber the member IDs.
- DClear the Virtual Chassis protocol.
How the community answered
(35 responses)- A3% (1)
- B83% (29)
- C6% (2)
- D9% (3)
Community Discussion
No community discussion yet for this question.