HPE6-A45 Exam Questions

The network administrator configures the commands shown in Exhibit 2. Which mismatch will cause an issue?

A company wants to implement 802.1X authentication to authenticate client devices on AOS-Switch ports. The company has a RADIUS server that uses PEAP authentication. Client authent...

An administrator wants to authenticate guests to ClearPass with captive portal. An administrator notices that some guests are unable to reach the captive portal page. What will res...

A customer wants to authenticate AOS-Switch managers to a RADIUS server. The CIO wants to assign different rights to different management users for granular access to device setup...

Exhibit 2 shows IGMP group sessions on Switch-2, which runs IGMP but not PIM. Switch-1 and Switch-3 do not have IGMP or PIM enabled. Client 1 begins to forward multicasts to 239.1....

Refer to the exhibit. Switch-1(config)# show running-config interface 1-20 running-configuration! interface 1 untagged vlan 20 aaa port-access authenticator exit #output the same f...

What is the minimum requirement for a device to pass local MAC authentication (LMA) on an AOS-Switch?

Refer to the exhibit. The network administrator wants to summarize routes as much as possible in between areas. What is the correct range to specify for the router OSPF Area 2 comm...

Refer to the exhibits. Switch-2, Switch-5, and Switch-6 currently have many OSPF routes to Area 1 networks. The network administrator wants to replace these routes with a single ag...

Refer to the exhibits. An AOS-Switch has the ACL shown in the exhibit. A network administrator then enters these commands: Switch(config)# mac-access-list standard myACL Switch(con...

Refer to the exhibits. The network administrator wants to set up mirroring of traffic from port 1 on Switch-1 to port 1 on Switch-2. Exhibit-2 shows the commands that the administr...

Refer to the exhibits. The network administrator enters the commands shown in Exhibit 2. What is the spanning tree status on A1 and A2?

A company has a Unified Communications and Collaboration (UCC) solution. A network administrator needs to configure the AOS-Switches to prioritize only the VoIP traffic. Where can...

Two AOS-Switches are OSPF neighbors. The network administrator wants routing to update as quickly as possible in the event of a failure on a neighboring switch. Which technology sh...

Refer to the exhibit. Network administrators want the network to use PIM-DM to route multicasts from Server 1 to receivers in VLAN 24. Which protocols should the administrators ena...

Switch-1# show access-list myList Access Control Lists Name: myList Type: Standard Applied: Yes SEQ Entry ---------------------------------------------------- 10 Action: permit IP...

The exhibits show the current operational state for routes on Switch-3. The company wants Switch-3 to send all traffic to 172.16.0.0/16 through Switch-2. Which single configuration...

An administrator needs to control traffic based on TCP or UDP application, as well as IP protocol, such as GRE or ICMP. What should the administrator configure for this purpose?

Refer to the exhibit. What is required for Switch-1 and Switch-2?

Refer to the exhibits. What is most likely to place to find the issue?

The company wants the fastest convergence and best load sharing of traffic over the links between Switch-1 and the VSF fabric. Which technology should the network administrator imp...

The exhibits show the current operational state for routes on Switch-3 to send all traffic to 172.16.0.0/16 through Switch-2 during normal operation. Which single configuration cha...

Switch-1 and Switch-2 are configured to provide VRRP in VLAN 2. Based on the output, what will happen when a client in VLAN 2 sends an ARP request for its default gateway IP addres...

A company has a wireless Aruba solution and wired users that connect to AOS-Switches. The company wants deep insight into the types of applications that wired users run. The compan...

Refer to the exhibit. Switch-1 is routing traffic to 192.0.2.0/24 over a less-than-optimal path. Which issue could prevent Switch- 1 from selecting the first route listed in the ta...

A network administrator wants to use an ACL, acl1, to control traffic from devices in VLAN 12 as the traffic is routed out of VLAN 12. The ACL should not control traffic within the...

An ACL Switch needs to use captive portals to integrate with an Aruba ClearPass Guest solution. The solution should allow guests to connect their own devices to the network, be red...

Refer to the exhibit. Why are these switches unable to achieve adjacency?

A company starts to have issues with too many rules in the dynamic ACLs applied to AOS-Switch ports. Administrators decide to remove some of the common rules from the dynamic ACLs...

Refer to the exhibit. An AOS-Switch connects to an unmanaged switch in a meeting room. The exhibit shows security settings for this port. Users report that they sometimes lose conn...

A network administrator plans to apply DSCP 46 to all traffic on a port. What is required for this configuration to work?

Refer to the exhibit. Network administrators set up PIM-DM to route multicast traffic from Server 1 to clients in VLAN 24. The multicasters are not active now, but the administrato...

A company uses MSTP and has AOS-Switches at the access layer. The company wants edge ports on the access layer switches to meet these criteria: They prevent all rogue switches that...

Refer to the exhibits. The IP phone in the exhibit is set up to complete 802.1x authentication to the network. How can the network administrator prevent a user on the computer from...

Refer to the exhibit. The network administrator wants to reduce failover time if a switch link in VLAN 100 goes down. What should the administrator do?

A company has AOS-Switches set up with captive portal and Aruba ClearPass on AOS-Switches. The solution seems to work for most guests. However, some guests wish their browsers are...

A network administrator needs to configure an AOS-Switch to classify traffic. Comparing QoS policy and global policy, what is one function that only a class-based QoS policy can fu...

What is a reason to create a virtual link between two OSPF routers?

A company has AOS-Switches deployed at sites with inexperienced IT staff. The main office network administrators want to track if configurations change on some switches. What would...

Refer to the exhibit. The access layer AOS-Switches currently run DHCP snooping on VLAN 2 and connection rate filtering on edge ports. They are at default settings for ARP protecti...

Network administrators decide to change OSPF Area 1 to a stub area in order to solve some performance issues. No routes are redistributed into Area 1. What is one implication of ma...

Refer to the exhibits. The network administrator needs to set up BGP between the two company switches, Switch-1 and Switch-2. The BGP connection does not establish. Based on the ex...

What is the FIRST step that the network administrator must take to redistribute the routes?

The best plan for AOS-Switches requires protection from incoming malware traffic generated from a worm-or virus-infected host. Which feature should be implemented to provide the re...

A network administrator can set the OSPF metric type on an AOS-Switch to Type 1 or Type 2. What is the difference?

A company has AOS-Switches, Aruba ClearPass, and Aruba AirWave. A network administrator needs to set up a new switch with the same settings found on other switches in the company....

A network administrator needs to set up an AOS-Switch to use port-based tunneled node for connected devices. However, the administrator wants the switch to forward traffic without...

Refer to the exhibit. Switch-1# show ip route IP Route Entries Destination Gateway VLAN Type Sub-Type Metric Dist --------------- --------------- ---- -------- -------- ------- ---...

Refer to the exhibit. A network administrator needs to alter myACL so that it permits all traffic that arrives in VLAN 2 and is destined to 10.1.0.0/24. Besides this change, the AC...

A network administrator wants to authenticate AOS-Switch managers to a RADIUS server. Managers should be assigned either read-only or full read-write level access based on the Serv...