A network administrator wants to configure a Comware switch to send HP Intelligent Management Center (IMC) sFlow samples. Where does a Comware switch direct sFlow samples?

Question

Options

• ATo the multicast address defined for sFlow collector
• BTo the IP address configured as the sFlow agent
• CTo the IP address configured as the sFlowtrap receiver
• DTo the IP address configured as the sFlow collector

• A
  6% (1)
• B
  6% (1)
• C
  13% (2)
• D
  75% (12)

Explanation

sFlow technology is a statistical-sampling-based network monitoring technology for high-speed switched or routed networks. sFlow technology samples network packets and sends the samples to a monitoring station. The information gathered by the sFlow technology is used to create a network traffic visibility picture. An sFlow monitoring system consists of an sFlow agent embedded in the switch and a centralized collector. The sFlow agent runs on the switch. It combines interface counters and flow samples and sends them across the network to the sFlow collector. Note: CLI Quick Configuration (not the setting of the sFlow collecter IP address on the first line) To quickly configure sFlow technology, copy the following commands and paste them into the switch terminal window: [edit protocols sflow] set collector 10.204.32.46 set collector udp-port 5600 set interfaces ge-0/0/0.0 set polling-interval 20 set sample-rate 1000 Figure : sFlow Technology Monitoring System

No community discussion yet for this question.