A network administrator is deploying HP 5800 switches at the access layer and wants to manage them with HP Intelligent Management Center (IMC). When SNMP is enabled on these switches, which version…

Question

Options

• AParameter Type: Select the version of SNMP (v1 or v2c) that is configured on the device to be
• BRead-Only Community String: Enter the read-only community string for this device in the Read-
• CRead-Write Community String: Enter the read-write community string for this device in the
• DSNMP version 2c

• A
  71% (39)
• B
  9% (5)
• C
  4% (2)
• D
  16% (9)

Explanation

On IMC auto discovery: The SNMP read and write community string configuration you enter here must match the SNMP configuration settings on the devices to be discovered and managed. Refer to each vendor's manual for information on setting the SNMP configuration parameters for each device type. In the basic auto discovery mode, only SNMP v1 is supported Note on IMC advanced auto discovery: To edit the SNMP parameters, verify that the radio button to the left of Edit SNMP Parameters is Do the following: added from the Parameter Type list. You can only add devices that are configured with SNMPv3 using SNMP templates. Therefore, you must create an SNMP template with the SNMPv3 parameters for this device before adding Only Community String field. This value must match the read only community string that is configured on the device to be added. Read-Write Community String field. This value must match the read-write community string that is configured on the device to be added.

No community discussion yet for this question.