H35-211_V2.5 Exam Questions
516 real H35-211_V2.5 exam questions with expert-verified answers and explanations. Page 9 of 11.
- Question #403
Which of the following measures can be adopted for flow control in GGPON? (Multiple choice)
- Question #404
Single-talk occurs during voice calls. The possible reason is (). (Multiple choice)
- Question #405
Check the protection configuration in OLT as follows: Huawei(config)=protect-group 0 protect-target gpon-uni-port workmode timedelay Huawei(protect-group-0)#protect-group member po...
- Question #406
Which statement about rogue ONU is correct? (Multiple choice)
- Question #407
When OLT processes priority tags, it can take which of the following methods? (Multiple choice)
- Question #408
For which of the following types of DBA bandwidth will the PON port upstream available bandwidth be reduced after the DBA horizontal board is configured and successfully used by th...
- Question #409
In the ONT configuration deployment of e Sight , you can configure multiple service templates. The parameters that can be set in the Multiple Service Template Management tab are ()...
- Question #410
The port numbers used by the SNMP protocol between the OLT and the u2000 network management system are (). (Multiple choice)
- Question #411
When adding a new NE on the U2000, it fails to add the new NE. What are the possible reasons? (Multiple choice)
- Question #412
OLT uplink can improve bandwidth and reliability through link aggregation. Which of the following modes are currently supported by OLT uplink aggregation? (Multiple choice)
- Question #413
When using Type B home networking, the mainstream application scenarios are (). (Multiple choice)
- Question #414
The main solutions to MAC address spoofing do not include (). (Multiple choice)
- Question #415
The IEEE 802.1X protocol architecture include (). (Multiple choice)
- Question #416
In GPON systems, Huawei recommends not using splitting at or above the second level. Which of the following networking configurations is incorrect? (Multiple choice)
- Question #417
With the development of business, bandwidth requirements are increasing. 10G PON technology can better adapt to network needs. Which of the following descriptions about 10G PON is...
- Question #418
The uplink rate of 10G EPON is (). (Multiple choice)
- Question #419
ONU cannot be automatically discovered. The possible cause of the failure is (). (Multiple choice)
- Question #420
When an FTTH user experiences a "no power after off-hook" fault, the possible causes are (). (Multiple choice)
- Question #421
In the FITH VolP service, call setup fails and a single-channel situation occurs. Which of the following reasons is impossible? (Multiple choice)
- Question #422
In Huawei's GPON system, which of the following methods are used to handle rogue ONUs with persistent light transmission? (Multiple choice)
- Question #423
In a GPON system, when Type B protection is enabled, which of the following situations will trigger protection switching? (Multiple choice)
- Question #424
In the construction of POL ODN network projects, what optical cables are suitable for feeder deployment? (Multiple choice)
- Question #425
Compared with GPON, which of the following options is only supported by XGS-PON? (Multiple choice)
- Question #426
What is the correct function of the IGIPv2 General Query message? (Multiple choice)
- Question #427
Whether the parameters in the traffic template are set correctly will directly affect the user's service quality. If the user's service encounters quality problems such as lag or p...
- Question #428
Which of the following modes does the PITP protocol support? (Multiple choice)
- Question #429
If access to the OLT is to be prohibited for illegal users, what access authentication options are supported? (Multiple choice)
- Question #430
After enabling some security features on an OLT, it was found that the forwarding of protocol packets for some services was affected. Which of the following options is not the caus...
- Question #431
When the LACP aggregation group is in non-load-sharing mode, the link recovery mode can be set to resilient or non-resilient. Which of the following options is incorrect? (Multiple...
- Question #432
In a GPON network, if there is a power outage at the user end, which of the following alarms will appear? (Multiple choice)
- Question #433
What factors need to be considered when designing optical cable routing in an ODN network? (Multiple choice)
- Question #434
Which of the following is not an influencing factor for ONU selection? (Multiple choice)
- Question #435
Voice call quality is poor (noisy, intermittent, or has an echo). What are the following possible reasons? (Multiple choice)
- Question #436
Among the following options, which one is incorrect in describing the key technologies of XGS- PON? (Multiple choice)
- Question #437
Which of the following statements about the characteristics of each layer of POL is reasonable? (Multiple choice)
- Question #438
In a GPON network, which of the following descriptions regarding the replacement of a faulty ONU is correct? (Multiple choice)
- Question #439
Which of the following options regarding the SIP protocol and configuration are incorrect? (Multiple choice)
- Question #440
When activating GPON ONU SIP voice services, what options require advance data planning? (Multiple choice)
- Question #441
Which of the following descriptions of Type B protection are correct? (Multiple choice)
- Question #442
In the POL network planning process, what output options are provided to users to guide project delivery and network software commissioning implementation? (Multiple choice)
- Question #443
Before the OLT performs traffic scheduling, it needs to classify service flows. Which of the following options can be used as a means of traffic classification? (Multiple choice)
- Question #444
In a GPON network, if the ONU's light receiving rate is too high, which of the following tools can be used to adjust it? (Multiple choice)
- Question #445
During POL ODN planning, what are the main options for collecting information based on network coverage requirements? (Multiple choice)
- Question #446
Which of the following conditions will trigger automatic protection switching for PON Type B single- homing protection? (Multiple choice)
- Question #447
In GFON networks, OLTs can support multiple service simulation functions to locate service faults. Which of the following options are correct? (Multiple choice)
- Question #448
Which of the following options fall within the optical channel loss range of the XGS-PON optical module? (Multiple choice)
- Question #449
Which of the following descriptions of Type C single-homing protection configuration are correct? (Multiple choice)
- Question #450
Which of the following options are incorrect in describing XGs-FPON data transmission? (Multiple choice)
- Question #451
Which of the following descriptions of the HTACACS and RADIUS protocols are correct? (Multiple choice)
- Question #452
Which of the following are the basic components of ODT? (Multiple choice)