H12-811_V1.0 Exam Questions
982 real H12-811_V1.0 exam questions with expert-verified answers and explanations. Page 19 of 20.
- Question #911Ethernet Switching Technologies
Refer to the following configuration of a switch interface. Which of the following statements is false? interface GigabitEthernet0/0/1 port link-type trunk port trunk pvid vlan 200...
trunk portPVIDVLAN taggingHuawei switch configuration - Question #912Ethernet Switching Technologies
On an STP-enabled switch, a port in the Learning state can transition to the Forwarding state only after the Forward Delay timer expires.
STPport statesForward DelayLearning state - Question #913Ethernet Switching Technologies
Which of the following parameters is used to elect the root bridge in STP?
STPbridge IDroot bridgeelection parameter - Question #914Datacom Network Fundamentals
What is the length range of an Ethernet_II frame that contains an Ethernet header?
Ethernet IIframe formatframe sizeMTU - Question #916Ethernet Switching Technologies
When two switches are connected through link aggregation, what are the requirements for the interfaces on the two switches?
link aggregationEth-Trunkinterface requirementsduplex mode - Question #917Ethernet Switching Technologies
Refer to the following configuration of an interface on a switch. What is the PVID of the interface? interface GigabitEthernet0/0/1 port hybrid tagged vlan 2 to 3 100 port hybrid u...
hybrid portPVIDVLAN tagginguntagged VLAN - Question #918Ethernet Switching Technologies
Which of the following statements is true about the Forward Delay timer of STP?
STPForward Delayport state transitionloop prevention - Question #919Datacom Network Fundamentals
Which of the following are true about the Ethernet data frame with the "Length/Type" field being 0x0806?
ARPEtherTypeEthernet IIframe format - Question #921Network Security Basics
What is the number range of an advanced ACL?
ACLadvanced ACLACL numberingaccess control list - Question #922IP Routing Technologies
As shown in the figure, RTA uses NAT and has an address pool configured to implement many- to- many non-NAPT address translation, so that hosts on the private network can access th...
NATaddress poolmany-to-many NATaddress exhaustion - Question #923Network Security Basics
A Layer 2 ACL can match information such as the source MAC address, destination MAC address, source IP address, and destination IP address.
ACLLayer 2 ACLMAC address filteringmatch criteria - Question #924Network O&M
After the administrator performs the configuration shown in the figure on a router, which of the following commands can be used to specify a short lease for addresses assigned usin...
DHCPlease timeDHCP configurationaddress assignment - Question #925Datacom Network Fundamentals
On the network shown in the figure, host A logs in to router A through Telnet and obtains the configuration file of router B through FTP on the remote CLI. How many TCP connections...
TCP connectionsTelnetFTPtransport layer - Question #926Datacom Network Fundamentals
Which of the following is the default port number of the Telnet server?
Telnetwell-known portsport numbers - Question #927Datacom Network Fundamentals
Which of the following network parameters can be allocated using DHCP?
DHCPIP address allocationDNS servergateway - Question #928WLAN Basics
Only one SSID can be bound to each radio of an AP.
SSIDAP radioVAPWLAN configuration - Question #929WLAN Basics
What is used as the data link-layer MAC address that identifies each VAP on an AP?
BSSIDVAPMAC addressAP identifier - Question #930WLAN Basics
Which of the following WLAN security policies support open link authentication?
WEPopen authenticationWLAN securitywireless encryption - Question #931WLAN Basics
Which of the following commands is used to configure the country code on an AC?
AC configurationcountry codeCLI commandsWLAN management - Question #932Datacom Network Fundamentals
The data link layer uses PPP encapsulation. The IP addresses of the two ends of the link can be in different network segments.
PPPdata link layerWAN protocolsIP addressing - Question #934Network O&M
Which SNMP version focuses on two main aspects, namely security and administration. The security aspect is addressed by offering both strong authentication and data encryption for...
SNMPv3SNMPauthentication encryptionnetwork management - Question #935IP Routing Technologies
If the MAC address of an interface is 00E0-FCEF-0FEC, the corresponding EUI-64 address is ( ).
EUI-64IPv6 addressingMAC addressaddress conversion - Question #936IP Routing Technologies
How many bytes are there in a basic IPv6 header?
IPv6header formatpacket structureheader size - Question #938Datacom Network Fundamentals
Which of the following statements are true about transport-layer protocols?
TCPUDPthree-way handshakewell-known ports - Question #939Datacom Network Fundamentals
The tree topology is a hierarchical star topology, facilitating network expansion. A consequence of this topology is that faults on a node at a higher layer are more severe.
tree topologynetwork topologyhierarchical designfault propagation - Question #940Network O&M
Which of the following information is displayed when an entered command is incomplete on the Versatile Routing Platform (VRP)?
VRPCLIerror messagescommand syntax - Question #941Ethernet Switching Technologies
Refer to the graphic, 00e0-fc99-9999 is a specific host MAC address learned by a switch through ARP, and the host changes the IP address three times.
MAC address tableARPswitch learningIP-MAC mapping - Question #942Datacom Network Fundamentals
UDP does not guarantee data transmission reliability and does not provide packet sorting and traffic control functions. It is suitable for the traffic that has low requirements for...
UDPtransport layerconnectionless protocolreliability - Question #943Datacom Network Fundamentals
Which of the following is not a characteristic of small campus networks?
campus networknetwork designsmall networknetwork characteristics - Question #944IP Routing Technologies
Which of the following packets are OSPF packets?
OSPFrouting protocol packetsLSAHELLO packet - Question #945IP Routing Technologies
Which of the following are valid static route configurations?
static routingroute configurationCLI syntaxnext-hop address - Question #946IP Routing Technologies
Which of the following statements regarding static routing and dynamic routing is incorrect?
static routingdynamic routingrouting comparisonlink failure recovery - Question #947Datacom Network Fundamentals
Which of the following descriptions regarding the TTL field of the IP packet is correct?
TTLIP packetroutingheader fields - Question #948IP Routing Technologies
Which of the following are features of the OSPF protocol?
OSPFlink-state routingarea divisiontriggered update - Question #949Datacom Network Fundamentals
If the IPv4 address of a host on a LAN is 192.168.1.1/30, the host will process IP packets with specific destination IP addresses. Which of the following IP addresses may be the de...
IPv4 addressingsubnet maskbroadcast addressCIDR /30 - Question #950IP Routing Technologies
Which of the following is the default value of the Router Dead Interval field in OSPF Hello packets on a broadcast network?
OSPFHello packetDead Intervalbroadcast network - Question #951Ethernet Switching Technologies
After a switch restarts, static MAC address entries saved on the switch remain in the MAC address table.
MAC address tablestatic MAC entryswitch restartpersistence - Question #952Ethernet Switching Technologies
Which of the following is correct regarding the configuration of the trunk port and access port on a switch?
trunk portaccess porttagged framesVLAN - Question #953Ethernet Switching Technologies
After an Eth-Trunk in LACP mode is created, devices on both ends send LACPDUs to elect the Actor. Which of the following parameters in LACPDUs determine the Actor election?
LACPEth-TrunkLACPDUActor election - Question #954Ethernet Switching Technologies
RSTP uses the proposal/agreement mechanism to shorten the time that an upstream port waits before transitioning to the Forwarding state, but no temporary loop occurs. Why?
RSTPproposal/agreementsynchronization mechanismloop prevention - Question #955Ethernet Switching Technologies
Assuming all STP enabled switches have the same bridge priority. The MAC address of switch A is 00-e0-fc-00-00-40, the MAC address of switch B is 00-e0-fc-00-00-10, the MAC address...
STProot bridge electionbridge priorityMAC address - Question #956Ethernet Switching Technologies
Which of the following port states are included in Rapid Spanning Tree Protocol (RSTP)?
RSTPport statesdiscardingforwarding - Question #957IP Routing Technologies
According to the one-armed routing configurations shown in the figure, even if ARP proxy is disabled on the sub-interface of R1, the Administration Dept and Finance Dept can still...
one-armed routingsub-interfaceinter-VLAN routingARP proxy - Question #958Ethernet Switching Technologies
If a device running STP receives an RSTP configuration BPDU, it discards the BPDU.
STPRSTPBPDU compatibilitybackward compatibility - Question #959Ethernet Switching Technologies
A Layer 2 switch works at the data link layer. As such, it can identify MAC addresses in data frames, forward data based on MAC addresses, and record mappings between MAC addresses...
Layer 2 switchMAC addressdata link layerMAC address table - Question #960Ethernet Switching Technologies
Which of the following statements is true about link aggregation in manual load balancing mode?
link aggregationmanual load balancingEth-Trunkactive interfaces - Question #961Ethernet Switching Technologies
As shown in the figure, which of the following ports will be in blocking state?
STPblocking stateport rolestopology - Question #962Ethernet Switching Technologies
When a switch receives a unicast data frame, if the destination MAC address of the data frame can be found in the MAC address table of the switch, the data frame is definitely forw...
MAC address tableunicast forwardingswitch behaviorframe filtering - Question #963
The network administrator performs the configuration shown in the following figure on RTA. If a user needs to be authenticated in the authentication domain named huawei, which of t...
- Question #964Network Security Basics
The rules in an ACL may overlap. If packets match the rules with loose conditions, the later ACL rules are not processed. In this case, packets cannot match the rules with strict c...
ACLrule orderingpacket matchingstrict vs loose conditions