H12-811_V1.0 Exam Questions
982 real H12-811_V1.0 exam questions with expert-verified answers and explanations. Page 20 of 20.
- Question #965
When the ACL in the following figure is configured on a Telnet server, only the device with an IP address of 172.16.105.2 can remotely log in to the Telnet server. bash Copy code a...
- Question #966
What is the main function of the DNS protocol?
- Question #967
Which of the following IEEE 802.11 standards supports a theoretical negotiated rate of 5 Gbit/s or higher?
- Question #968
Which of the following packets are exchanged between STAs and an AP to obtain the AP's SSID before association with the AP?
- Question #969
On a Layer 2 WLAN, STAs use an AC as their gateway.
- Question #970
Which of the following fields are included in an MPLS header?
- Question #971
With SNMP, an NMS can only display the device running status but cannot deliver configurations.
- Question #972
When a host uses the stateless address autoconfiguration solution to obtain an IPv6 address, the host cannot obtain the DNS server address.
- Question #973
Refer to the display startup command output shown in the figure on an AR2200 router. Which of the following statements about the command output is false? <Huawei>display startup Ma...
- Question #974
Which of the following methods can be used to assign service VLANs during campus network planning?
- Question #975
You can run the "pwd" and "dir" commands on the Versatile Routing Platform (VRP) to view file information in the current directory.
- Question #976
(When a network engineer enters a command, the following information is displayed: Error: Unrecognized command found at 'A' position. Which of the following statements is true abou...
- Question #977
Which of the following routing protocols are dynamic routing protocols?
- Question #978
If a routing table contains multiple routes to the same destination network, what are these routes called?
- Question #979
Which of the following is a dynamic IGP routing protocol?
- Question #980
Which of the following are not main functions of routers?
- Question #981
What is the main function of a dynamic routing protocol?
- Question #982
Which layer of the OSI model does a router work at?
- Question #983
Which of the following OSPF packets can be used to confirm the received Link State Update (LSU) packets?
- Question #984
Which of the following statements is true about active interface election for an Eth-Trunk in LACP mode?
- Question #985
The IP addresses of VLANIF interfaces on the same switch must be different.
- Question #986
Which of the following descriptions regarding the STP forwarding state is incorrect?
- Question #987
An Eth-Trunk interface can be used only as a Layer 2 interface.
- Question #988
Loops may cause broadcast storms on a Layer 2 network.
- Question #989
ICMP packets do not contain port numbers. Therefore, NAPT cannot be used.
- Question #990
The administrator performs the configuration shown in the figure on a router, and a host is connected to Gi/0/0 of the router. Which of the following statements is true about the I...
- Question #991
An administrator cannot log in to a Huawei router through Telnet, but other administrators can log in to the router. Which of the following are possible causes?
- Question #992
Each network device running SNMP runs an agent process locally.
- Question #993
By default, in the SNMP protocol, which port number is used by the proxy process to send alarm messages to the NMS?
- Question #994
The IPv6 address architecture does not include which of the following address types?
- Question #995
Which of the following statements about IPv6 anycast addresses are true?
- Question #996
Network Functions Virtualization (NFV) implements software-based network application deployment.