H12-211_V3.0 Exam Questions
1,013 real H12-211_V3.0 exam questions with expert-verified answers and explanations. Page 8 of 21.
- Question #354
The load balancing modes of the two ends of the Eth-Trunk can be inconsistent.
- Question #355
For the network shown in the following figure, the switch uses the sub-interface pair of the machine interface and the router. Which of the following configurations can fulfill thi...
- Question #356
In the following options, which is the necessary technology to enable a host with an IP address of 10.0.0.1 to access the Internet?
- Question #357
As shown in the following figure, from the perspective of the security corner, Router A refuses to receive OSPF packets, GRE packets and ICMP packets received from G0/0/1. Which of...
- Question #358
As shown in the following figure, which of the following configurations can be used to prevent Host A from accessing Host B HTTP service. Host B can not access which service of Hos...
- Question #360
The multicast address FF02::1 represents all nodes in the link-local range.
- Question #361
In P2P network, DD packet does not need to be sent when the OSPFv3 adjacency is established.
- Question #362
The simplest form of IPv6 address 3001: 0DB8: 0000: 0000: 0346: ABCD: 42BC: 8D58 is?
- Question #363
When the host adopts DHCPv6 stateless autoconfiguration, which DHCPv6 message is sent by the host to request configuration information?
- Question #364
What is the length of the IPv6 multicast address flag field?
- Question #365
Which of the following statements about the Node Segment is wrong?
- Question #366
Which of the following are the actions of the MPLS label? (Muitiple choice)
- Question #367
If two Huawei S5710 switches are interconnected using a 10 Gigabit optical module, the working mode of the interconnect port defaults to full duplex.
- Question #368
On the Huawei ARG3 router, the -i parameter of the Ping command in the VRP is used to set ?
- Question #369
The following statement about the TTL field in the IP packet header, which is correct?
- Question #370
Which of the following statements about ICMP messages is correct? (Muitiple choice)
- Question #371
How does the VRP platform represent the third slot of the router, the sub-card No. 0 and the GE port No. 2.
- Question #372
Which of the following statements about the Spanning Tree Protocol Root Bridge election is correct?
- Question #373
In standard STP mode, which of the following ports on non-root switches forward the BPDUs with TC bits set generated by the root switch?
- Question #374
The Message Age in the configuration BPDU sent by the root bridge in the STP protocol is 0.
- Question #375
Which of the following parameters should be considered when electing a root port in STP? (Multiple choice)
- Question #376
As shown in the following figure, assume that all routers run OSPF at the same time. Which kind of router is BDR in this network?
- Question #377
The routing table shown below, which of the following statement is correct? (Multiple choice)
- Question #378
As shown in the figure below, which network device can Host A and Host B use to communicate?
- Question #379
The router output information is as follows, which of the following statement is wrong?
- Question #380
Which of the following is not included in the routing table?
- Question #381
Which of the following statement about the OSPF backbone area is correct?
- Question #382
What are the advantages of the OSPF protocol? (Multiple choice)
- Question #383
A DHCP server in the enterprise network is being used to allocated IP addresses to hosts. An administrator discovers however that some hosts are obtaining IP addresses outside of t...
- Question #385
The aggregation port of the router can be configured with a routing subinterface.
- Question #386
Which VLAN partitioning method is most appropriate when the host frequently moves the location?
- Question #387
On the VRP platform, the role of the command "interface vlan <vlan-id>" is ().
- Question #388
NAPT distinguishes the IP addresses of different users by protocol numbers in TCP or UDP or IP packets.
- Question #389
Which message need to send when needing to terminate a PPPoE session?
- Question #390
Which of the following are the advantages of the PPP protocol? (Multiple choice)
- Question #391
The network shown below. Which of the following configurations enables all hosts to communicate with Host C, but Host A and Host B cannot communicate?
- Question #392
As shown in the figure: IPsec VPN is used to transfer data between two hosts. In order to hide the real IP address and ensure the security of data as high as possible, which mode a...
- Question #393
Apply the following ACL in Telnet: which of the following statement is correct? acl number 2000 rule 5 deny source 172.16.105.30 rule 10 deny source 172.16.105.40 rule 15 deny sour...
- Question #394
Which of the following IPv6 addresses is a link-local address?
- Question #395
Which field in the IPv6 header acts like the TTL field in the IPv4 header?
- Question #396
What are the three main roles in the DHCPv6 basic protocol architecture? (Multiple choice)
- Question #397
The value of the MO flag in the RA message sent by the DHCPv6 service is 01. Which of the following methods does the host use to automatically configure the address?
- Question #398
Which of the following statements about the S field in the MPLS packet header is correct? (Multiple choice)
- Question #399
Refer to the configuration output. <Huawei>reset saved-configuration Warning: The action will delete the saved configuration in the device. The configuration, will be erased to rec...
- Question #400
On the VRP interface, use the command startup saved-configuration backup.cfg to configure the backup.cfg file for the next startup.
- Question #401
Which of the following states is the STP port converted between exist Forward Delay? (Multiple choice)
- Question #402
Which of the following parameters should be considered when electing a root port in STP? (Multiple choice)
- Question #403
Which of the following port states does not the RSTP protocol include?
- Question #404
Which router is the BDR in this network, as shown in the figure below?
- Question #405
It is known that the routing table of a router has the following two entries: If the router wants to forward a message with a destination address of 9.1.4.5, which of the following...