H12-211_V3.0 Exam Questions
1,013 real H12-211_V3.0 exam questions with expert-verified answers and explanations. Page 7 of 21.
- Question #304
The broadcast address is a special address in the network address where the host bits are all set to 1. It can also be used as a host address.
- Question #305
As shown in the figure, if the administrator wants to improve the performance of this network, which of the following is the most appropriate?
- Question #306
If the command is executed on the router: user-interface maximum-vty 0, the following statement which is correct?
- Question #307
On the VRP operating platform, what is the command to display the current interface configuration in the interface view?
- Question #308
Regarding the conflict domain and the broadcast domain, the description which is correct? (Muitiple choice)
- Question #309
What is the priority of the bridge priority in the IEEE 802.1D standard?
- Question #310
In RSTP mode, interfaces in the Discarding state discard received data frames but maintain the MAC address table based on received data frames.
- Question #311
As shown in the figure below, which port of the following switch will become the designated port?
- Question #312
The device port running STP is in the Forwarding state. Which is correct?
- Question #313
As shown in the network below, the host has an ARP cache. Which is correct? (Muitiple choice)
- Question #314
In the network shown in the following figure, all routers run the 0SPF protocol, and the top of the link is the value of the Cost value. What is the Cost value of the RA1 routing t...
- Question #315
As shown in the following figure, host A does not have a gateway configured. Host B has a gateway ARP cache. Which is correct? (Muitiple choice)
- Question #316
In Huawei AR routers, by default, the value of the RIP priority is?
- Question #317
When OSPF establishes adjacency, which of the following must be consistent? (Muitiple choice)
- Question #318
What are the advantages of the OSPF protocol? (Muitiple choice)
- Question #319
What is the destination IP address of the DHCP DISCOVER packet?
- Question #320
If an Ethernet data frame has Length/Type = 0x8100, then the payload of this data frame cannot be? (Muitiple choice)
- Question #321
The configuration information of an interface of a router is as follows. Which port can receive the data packets of this VLAN?
- Question #322
What should I do when the trunk port sends a data frame?
- Question #323
Which of the following features does HDLC have? (Muitiple choice)
- Question #324
The output information of a router is as follows. Which is correct? (Muitiple choice)
- Question #325
What is the default ACL step size on the G3 series routers?
- Question #326
What is the range of advanced ACL?
- Question #327
Which of the following protocols is the IPsec VPN architecture?
- Question #328
About the matching mechanism of ACL, which is correct? (Muitiple choice)
- Question #329
The network management workstation manages the network device through the SNMP protocol. When the managed device has an abnormality, what kind of SNMP packet will the network manag...
- Question #330
The router does not need to re-encapsulate the data link layer when forwarding IPv6 packets.
- Question #331
There are 4 routers in a broadcast network, and all 4 routers run OSPFv3 protocol. If all router DR priorities are not 0, how many adjacencies are there in the network?
- Question #332
Which of the following statements about the Prefix Segment is wrong?
- Question #333
About the TTL field in the IPv4 header, which is correct?
- Question #334
What is the value range of the DSCP field in the IPv4 header?
- Question #335
UDP is connectionless and must use which to provide the reliability of the transmission?
- Question #336
Because the TCP protocol uses three-way handshake mechanism when establishing and closing connections, TCP supports reliable transmission.
- Question #337
Which method VRP does not support to configure the router?
- Question #338
In which view can the administrator modify the device name for the router?
- Question #339
Which of the following states does the STP protocol elect to perform port roles?
- Question #340
What is the total length of the Flag field in the RSTP BPDU message?
- Question #341
Which of the following is not the reason that RSTP can improve the convergence speed?
- Question #342
Which of the following statements about the edge port in the RSTP protocol is correct?
- Question #343
A switch running STP can be converted to the Forwarding state after waiting for the forwarding delay in the Learning state.
- Question #344
In Huawei AR routers, what is the priority of the static routing protocol by default?
- Question #345
As shown in the following figure, all routers run OSPF. Which device ABR?
- Question #346
As shown in the following figure, if the host has an ARP cache and host A sends a packet to host B, what is the destination MAC address and destination IP address of the packet?
- Question #347
What types of networks are supported by the OSPF protocol? (Muitiple choice)
- Question #348
How many types of OSPF packets are there?
- Question #349
When upgrading the router software using the FTP protocol, which transfer mode should be selected?
- Question #350
Which message does the DHCP server use to confirm that the host can use the IP address?
- Question #351
A Windows host is started for the first time. If the IP address is obtained by DHCP, what is the source IP address of the first packet sent by this host?
- Question #352
What is the range of VLAN IDs that users can use?
- Question #353
If a port has the following configuration information, which port does the VLAN TAG carry when transmitting data frames of the VLAN?