H12-211_V3.0 Exam Questions

Which of the following configurations regarding default route configuration is correct?

The IPv6 address architecture does not include which of the following address types?

Which of following may be the reasons that cause Frame Relay PVC to work abnormally? (Choose three)

As shown in the following figure, switch A and router A are connected through two links. The two links are aggregated in manual load balancing mode. The aggregation port number is...

How can the default route be generated? (Choose all that apply.)

An Ethernet port can work one of three duplex modes, whereas an Optical Ethernet port only supports one single mode. Which of the following represents this mode?

If the MAC address of an interface is 0EE0-FFFE-0FEC, the corresponding EUI-64 address is ( ).

Which of the following commands can be used to view the current configurations on a Huawei router?

Refer to the configuration output. <Huawei>reset saved-configuration Warning: The action will delete the saved configuration in the device. The configuration will be erased to reco...

Two routers establish an IPsec tunnel, which of the following does not need to be the same on both peering devices?

What are the advantages of OSPF?

Refer to the graphic. RTA and RTB are running RIPv1. RTA has advertised 10.0.0.0 and 192.168.1.0 to the RIP network. Which routes will exist in the IP routing table of RTB? (Choose...

A serial interface of a Huawei router currently using HDLC needs to assign PPP as the encapsulation protocol. Which of the following commands is required to be configured at the se...

On VRP platform, the command lines are classified into four levels in increasing priority: Visit level, Monitoring level, Configuration level, and Management level. At which level,...

The network administrator wishes to forward data over an Eth-trunk, however associated member interfaces operate at different rates. In terms of the resulting behavior, which of th...

In the case of Huawei router, the Tracert command uses UDP to encapsulate probe packets.

Refer to the graphic. Host A and Host B use VLAN routing to facilitate communication. When interface G0/0/1.2 of RTA receives a frame from Host B, what will RTA do?

Which of the following network types does OSPF support? (Multiple Choice)

Which of the following statements regarding static and dynamic routing is incorrect?

According to the following configuration of Router C, how many global unicast address prefixes are advertised by Router C?

Which of the following commands can be used to display mapping relationship between network address and DLCI?

The network administrator wishes to transmit data between two end stations. The network interface cards of both devices operates at 100Mbps however one supports half duplex while t...

What is the maximum number of member interfaces supported by a single Eth-Trunk?

Which of the following configurations regarding static route are correct? (Choose all that apply)

You can configure a static route on a broadcast interface by specifying the next-hop IP address or outbound interface.

While inspecting packets in the network, a network administrator discovers a frame with the destination MAC address of 01-00-5E-A0-B1-C3. What can the administrator determine from...

On Huawei switches, VLAN 4095 cannot be created and VLAN 1 cannot be deleted.

Refer to the configuration output. The administrator configured the device using the commands in the configuration output. Regarding these commands, which statement is false?

The output of the "display vlan" command on a switch is as follows. Which of the following statements are true?

Which of the following entries is not included in the routing table?

Which of the following statements regarding link-state database and routing-table of a "single" OSPF area are correct? (Choose two)

An administrator connects two switches together in a local enterprise network. The ports of one switch support Fast Ethernet, while the ports of the other switch support Gigabit Et...

The Eth-Trunk frame forwarding mechanism used to prevent changes in the data sequence forwards frames based on which of the following parameters?

Which of the following must be used to establish the configuration environment when a router is powered on for the first time?

The IKE protocol is used to set up an SA for IPsec automatic negotiation. Identity authentication can be performed when the IP address of the initiator changes dynamically.

Which of the following statements is true about the MAC address table of a switch?

Which area ID is used by OSPFv3 to identify the backbone area?

If AH and ESP are both required to protect data streams between IPsec peers, how many Security Associations (SA) are required in total?

Refer to the configuration output. Following configuration, a host is connected to the interface Gigabit Ethernet 0/0/1 of the router. Which IP address will the client obtain?

Which of the following problems are caused by routing loops? (Choose three)

Refer to the graphic. Which of the following statements is correct when this router forwards the packet to the destination host 9.1.4.5?

Which of the following data packets are the OPSF protocol packets encapsulated into?

On Huawei switch, which of the following commands can be used to set port duplex mode as "auto negotiation"? (Choose two)

Two routers are configured with OSPFv3. OSPFv3 is enabled on all interfaces of each router. Which of the following is true in the event that the network administrator does not conf...

If a network's broadcast address is 172.16.1.255, which of the following addresses can be the network address?

Refer to the graphic. IPsec VPN uses ESP to encrypt which fields?

Refer to the command output. [Huawei]rip 1 [Huawei-rip-1] version 2 An administrator wishes to configure RIP. Which other command needs to configured for RIP routes to be advertise...

Which of the following parameter settings for terminal emulation are correct when configuring a Huawei router through the Console port?

The following configuration commands implement route backup on RTA for a route to the same destination 10.1.1.0.

Which of the following is abbreviation of VRP?