H12-211_V3.0 Exam Questions

The administrator uses the ping command on the host to test connectivity to the website The command line shows a request time out. The administrator displays the ARP entries for th...

There are two routers (RTA and RTB) between the source device and destination device. The Tracert command is used to detect the path between the two devices. During detection of th...

Which of the following statements are true about ICMP messages? (Multiple Choice)

Which of the following protocols is used in Frame Relay to map the address to DLCI dynamically?

What is the main function of DHCP Discover packets?

Which of the following methods are supported by VRP platform to configure the router? (Choose three)

In the MPLS domain, the full name of LER is label egress router.

Refer to the graphic. The switch is operating using STP. All default parameters have been maintained. Which port will be assigned a designated port role?

According to the topology and configuration of interconnected interfaces of switches shown in the figure, the data frame tagged with VLAN 10 can be forwarded correctly between the...

In the VRP system, what are the functions of Ctrl+Z?

On an FR network, when the fr inarp command is executed, the interface where static address mapping entries have been configured sends an Inverse ARP Request packet to the remote d...

An administrator discovered he/she was unable to use TFTP to transfer files to the router. Which of the following describes the likely reason for this?

Which of the following types can ICMP packets be classified into? (Choose two)

An authenticator router has been configured with two domains named "Area1" and "Area2", following which a user is created with the username "huawei" and the password "hello" for au...

NAPT allows for multiple internal addresses to be mapped to a single public address. How does NAT distinguish between the different private addresses when mapping to the same publi...

FTP and TFTP can be used to update the system file on Huawei routers. Which of the following statements are correct? (Choose three)

In Layer 2 mode, the transmission rate of an Eth-Trunk interface is determined by which of the following? (Choose all that apply.)

Which of the following statements about the "ip route-static 10.0.2.2 255.255.255.255 10.0.12.2 preference 20" command is true?

An ACL does not filter traffic generated by the Huawei device towards other devices, but only filters forwarded traffic, including traffic generated by other devices to access the...

A network administrator wishes to implement VLAN 10 to isolate certain users. It is common however for these users to often change their physical location. Which of the following V...

What is the total length of the VLAN frame defined by IEEE 802.1Q?

When a network engineer enters a command, the following information is displayed: Error: Unrecognized command found at '^' position. Which of the following statements is true about...

Which of the following formats represent an accurate condensing of the IPv6 address 2031:0000:720C:0000:0000:09E0:839A:130B? (Choose two).

After the keepalive function is enabled for a GRE tunnel, the local end of the GRE tunnel sends a keepalive packet to the remote end every 10s.

Two routers have established a point-to-point network using PPP. The administrator has configured the routers to run OSPF in the same area with the same router ID, what behavior wi...

According to the default value of route preference on the VRP platform, which of the following represent the correct sequence for direct route, static route, RIP and OSPF if they a...

A configured internal host of a private network wishes to access the internet. What must be configured on the enterprise network egress router in order to achieve this? (Choose all...

Which of the following statements regarding the DR in an OSPF network are correct? (Choose two)

Which of the following parameters is not used by Advanced ACL?

Which of the following WLAN standards support operation in the 5GHz range? (Choose all that apply)

In order to check if the interface serial 1/0/0 is working in either DCE or DTE mode, command ( ) is used.

When an administrator first initializes the router, a warning is displayed. <Huawei> Warning: Auto-Config is working. Before configuring the device, stop Auto-Config. If you perfor...

A DHCP Offer packet can carry only one DNS server address.

Refer to the graphic. The routing table includes direct routes and static routes and the preference of the direct routes cannot be changed.

Which of the following parameters must be specified when configuring static mapping for Frame Relay network? (Choose two)

After checking the OSPF neighbor state, the administrator discovers that the router has established a TWOWAY state with the peering router. What can be understood from this informa...

A user logged into a VRP supported device through telnet, but when attempting to configure the device, found that he is unable to use the system-view command to enter the system-vi...

On Huawei VRP platform, which of the following can be used to invoke the history command saved by the command line interface? (Choose two)

Refer to the graphic. An administrator has configured RIPv2 in the two routers. What will happen after configuring the following commands: (Choose all that apply)

Refer to the configuration output. Which of the following statements regarding ACL 2001 is correct?

Host A wishes to send data to host C, and generates an ARP request to obtain the destination MAC address. Which statement is true?

A client failed to transfer a file to the FTP server, but found the IP connectivity was without problem. The client assumed that the problem was with the port configuration. The bl...

As shown in the preceding VTY configuration, the user privilege level is set to 3.

Refer to the graphic. An administrator has configured OSPF on the two routers, following which he then implements the command silent-interface s0/0/1 on RTA. What effect will this...

In STP, the priority of the STP root switch ranges from 0 to 65536.

Refer to the configuration output. The administrator wishes to configure the DHCP server pool in order to assign an IP address to the customer's terminal device. Which command shou...

Which of the following commands is used to enter the system-view from the user view on a Huawei router?

Which of the following statements regarding the routing table are correct? (Choose all that apply.)

In a network supporting IPv6, OSPF no longer supports which feature?

Interface G0/0/1 on RTA contains a MAC address of 00e0-fc03-aa73 and is configured with the IPv6 address 2001::2E0:FCFF:FE03:AA73. Which method is most likely to have been used to...