H12-211_V3.0 Exam Questions

If Host B also configured the IP address as "192.168.1.1/24", an IP address config will occur. What will happen as a result?

Which of the following statements regarding the router ID in OSPF are incorrect? (Choose three)

If a network's address is 192.168.1.0, the broadcast address of the network is 192.168.1.255.

Which of the following statements are true according to the following command output?

Assume that the router has learnt the best route to the same destination by using RIP, OSPF and Static Route respectively. By default, the Huawei router will select the route learn...

On Huawei devices, you can use the undo summary command to prohibit automatic route summarization of RIPv2.

Refer to the graphic. In the private network, RTA dynamically assigns a public address from the address pool to hosts without port translation. Host C wishes to access the public n...

With what kind of routers does a DRother router exchange link state information and route information? (Choose two)

Which of the following statements about a designated port working in RIPv2 multicast mode are true? (Choose three)

An administrator wishes to update the VRP software of company's AR2200 router. How can this be achieved? (Choose three)

When configuring the PPP authentication method as PAP, which of the following operations are necessary? (Choose three)

What will the destination MAC address be at the moment a frame is transmitted by the host, when the router is the IP destination?

InARP resolves the protocol address of the remote device on each virtual circuit, including IP addresses and IPX addresses.

A RIP router receives the routing update information from its neighbor. Which of the following statements regarding routing update are correct? (Choose three)

Which of the following statements about collision domains and broadcast domains are correct? (Choose three)

According to the configuration on R1 shown in the following figure, the two PCs can correctly access the ISP network.

Which of the following commands can be used to display the routing table on a Quidway router?

Which of the following statements about router IDs are true? (Choose two)

When configuring a router as a PPPoE client, which configuration is not necessary?

Two routers are connected through serial interfaces and support PPP encapsulation. Which parameters must be negotiated to establish the PPP connection? (Choose three).

Refer to the graphic. OSPF is used on four routers that are in the same area and on the same network segment. In this scenario, OSPF selects one DR and multiple BDRs to ensure back...

What is the total length of the port ID in STP?

Which of the following applications can be used to detect the path along which the data packets are transmitted from the source to the destination?

Which of the following statements are true about ACL deployment on Huawei devices? (Choose all that apply)

Which of the following statements are true about STP BPDUs?

A DHCP Unique Identifier (DUID) in DHCPv6 can be configured in VRP using which formats? (Choose two).

Which of the following address types are of IPv6 addresses?

Which of the following authentication method is more secure for PPP?

When both ends running PPP protocol detect that the physical link is active, the link state will transit from dead to establish. Which of the following protocols is used to negotia...

Which of the following commands is used to display the current running state and configuration of RIP?

A router functioning as a Proxy receives an ARP request packet, but finds that the destination address in the packet is not intended for itself. In this case, what will the router...

In the PPP protocol, which of the following encryption algorithms is used by CHAP?

Which of the following statements are correct about TTL field in IP packet? (Choose two)

The network administrator attempts to add interface G0/0/1 on Switch A to Eth-trunk 1, however the command fails. Which of the following may cause this?

During STP calculation, the port cost is associated with port bandwidth. Which of the following statements about the relation between port cost and port bandwidth is true?

Which of the following commands can switch a view from the system view to the user view?

An administrator of a company supporting a large enterprise network wishes to implement OSPF on the network as opposed to RIP. Which of the following points should the administrato...

In an RIP process on a Huawei device, which of the following configurations are correct for advertising network 10.1.1.1/30? (Multiple Choice)

On the VRP, what is the function of the "interface vlanif <vlan-id>" command?

OSPF allows for "multiple" processes. By default, OSPF selects a process whose number is ( ).

Refer to the configuration output. RTA has been configured using AAA as shown, and associated with the "huawei" domain. For users in the huawei domain, which authentication-scheme...

On the interface serial 1/0/1 of RTA, the command "ip address unnumbered interface loopback 0" has been configured. Which following statements are correct? (Choose two).

A user can view the information for the RIP protocol on a router. What does "Age time" in the returned result of the command mean?

Two routers are connected via serial interfaces, for which the link-protocol is PPP. The network administrator wishes to configure PPP authentication to improve security on this li...

When using VRP, which of the following commands is used to configure the PPP authentication method as PAP?

Which of the following regarding Frame Relay DLCI are correct? (Choose three)

The MAC address table of a switch is as follows. If the switch receives a data frame whose destination MAC address is 5489-9885-18a8 from Eth0/0/2, which of the following statement...

How many domains can be configured on a Huawei router?

How is mapping performed on a DTE device in a Frame Relay network?

What are the three protocol components defined by PPP? (Choose three).