EW0-200 Exam Questions

In an Extreme switch, all ports are enabled by default. If a port is disabled however, the link will also be disabled.

Which layer of the OSI reference model is responsible for formatting data used by the application layer?

Given the following diagram, which command would you use to send the switch active configuration file to the TFTP server?

In addition to maintaining an internal log, ExtremeWare supports remote logging feature via the UNIX syslog facility.

Which of the ExtremeWare features will allow you to increase bandwidth and resiliency by using a group of ports to carry traffic in parallel between two switches?

TCP's method of flow control is called sliding window.

The Rip hold timer to remain a route in the routing table without receiving updates is?

Which CLI command would enable you to schedule a configuration download to occur at regular intervals?

Which of the following is a predefined protocol filter on an Extreme switch?

When using IEEE 802.1D Spanning Tree Protocol, ExtremeWare supports VLANs in different STP Domains to share the same port when tagged.

An Extreme Switch is shipped with a pre-configured VLAN called DEFAULT that has all switch ports as tagged members.

You are taking steps to secure SNMP access to your switches by turning off SNMP access to the switches. What is the minimum action you need to perform?

The OSPF Area 0.0.0.0 is always pre-configured on an Extreme switch as a ___________ area type.

OSPF supports two levels of routing hierarchy represented by an:

Which of the following methods can be used to access an Extreme Networks switch?

When typing commands, the ExtremeWare CLI will auto-complete a command if followed with this keystroke:

The RFC 1918 describes the use and benefits of IP address space for private Internets. The following IP address 192.168.260.1/24 can be considered as a valid private IP address.

Which is the proper net mask for a class b network with a subnet of 6 bits?

The CLI command: configure vlan corporate ipaddress 10.10.101.0/24 is a valid command.

What is the maximum recommended number of subnets for a multinetted VLAN?

The modular Alpine switches support the following legacy WAN modules: (Choose all three that apply)

In CSMA/CD, where does CS stand for?

ExtremeWare does not support the exterior gateway protocol ?BGP4 in any of the Extreme Networks switch products.

What can possibly cause the following error?

Which CLI command is used to see the active connections to the switch.

Given the following diagram, how would you disable ports 3 through 8 on module 1 and all ports on modules 3 and 4?

Per Extreme switch port the maximum number of 802.1D spanning tree protocol domains is:

What is the maximum number of FDB entries in a Summit 7i?

What is the well-known port number for Telnet?

The acronym TCP/IP stands for:

What is the result when the CLI command: disable stpd port 4:1-4:8 is entered,?

In an Extreme Switch, a VLAN configured for routing can support only one physical Ethernet port.

RIP supports the distribution of non-originated RIP routes using a command beginning with: enable rip export.

The Spanning Tree Protocol is designed to:

When a port is added to a tagged VLAN, jumbo frame support must be enabled to compensate for the increased frame size.

A router using split horizon:

Upgrading the BootROM on a Summit 48i switch is done via the CLI command:

Classless routing and VLSM are supported by ExtremeWare.

There are two types of the Ethernet protocol, Ethernet2 developed by DIX and 802.3 developed by the IEEE.

The IEEE specification standard for the Spanning Tree Protocol is the:

What CLI command was executed and results in the system returning an error as follows:

This type of OSPF router has its router interfaces connected into multiple OSPF areas.

How many bits are reserved for the 802.1p priority in an 802.1p+Q tag

A Summit 5i switch is able to store up to two separate configuration files in the locations called IMAGE1 and IMAGE2.

Which of the following sequences identifies a TCP three-way handshake?

In spanning tree algorithm, the switch with the ___________________ is elected as the root bridge.

In a Summit 5i switch, a MAC address must be configured for each physical port before routing can be configured.

Which CLI command will remove the IP address that has been assigned to the default VLAN?

In ExtremeWare user account names and VLAN names share the same name space. Therefore a user named efault?cannot be created.

When multiple VLANs need to be configured on one physical port, all these VLANs must be configured with a tag.