You have finished deploying SANTap in a RecoverPoint CRR environment. At Site 2 everything looks fine. However, at Site 1 you see the following message on the RecoverPoint Management Application:

WARNING: RPA cannot access discovery AVT: 7001248288220000 ; Site1 ; RPA1 in Site1 ; Cisco - CVT22-2109000dec3c3182 You have checked that back-end and front-end VSANs are properly configured with the correct members in each. Which action can you take to perform a full discovery of ITLs and recreation of AVTs to fix this issue?

Question

You have finished deploying SANTap in a RecoverPoint CRR environment. At Site 2 everything looks fine. However, at Site 1 you see the following message on the RecoverPoint Management Application:

WARNING: RPA cannot access discovery AVT: 7001248288220000 ; Site1 ; RPA1 in Site1 ; Cisco - CVT22-2109000dec3c3182 You have checked that back-end and front-end VSANs are properly configured with the correct members in each. Which action can you take to perform a full discovery of ITLs and recreation of AVTs to fix this issue?

Accepted Answer

A. SSH as 'admin' and run the refresh_santap_view command

Answer

B. Refresh the splitters on the RecoverPoint Management Application

Answer

C. Rescan the SAN on the RecoverPoint Management Application

Answer

D. SSH as 'admin' and run the get_santap_view command

You have finished deploying SANTap in a RecoverPoint CRR environment. At Site 2 everything looks fine. However, at Site 1 you see the following message on the RecoverPoint Management Application…

Question

Options

How the community answered

Community Discussion