Dell-EMC
E22-275 · Question #60
You are trying to configure AVT zones for a SANTap environment in RecoverPoint using a new MSM 18/4 card installed in an existing director. You connect using SSH into the RPA as the 'admin' user and…
The correct answer is C. Port 23 is disabled on the switch. See the full explanation below for the reasoning.
Question
You are trying to configure AVT zones for a SANTap environment in RecoverPoint using a new MSM 18/4 card installed in an existing director. You connect using SSH into the RPA as the 'admin' user and run config_santap_avt_zones. You provide all the necessary switch information but the command fails repeatedly. What is the possible reason for this behavior?
Options
- APort 21 is disabled on the RPA
- BPort 22 is disabled on the switch
- CPort 23 is disabled on the switch
- DPort 443 is disabled on the RPA
How the community answered
(27 responses)- A4% (1)
- B19% (5)
- C70% (19)
- D7% (2)
Community Discussion
No community discussion yet for this question.