E20-611 Exam Questions

Your customer is serially connected using PPP from a management station to an array. What is the maximum baud rate that can be used for a dial-up networking environment?

Which type of session is required to reset the domain security to an established storage domain?

Your customer with a RAID 6 environment experiences data loss due to disk drive issues. Which type of fault is this considered?

Where would a Customer Engineer find documentation explaining Test and Acceptance Criteria (TAC)?

Your customer has experienced problems viewing target LUNs from one of their HP-UX hosts. The Support Center has requested a data collection. Which EMC supplied utility should be r...

Click the Exhibit Button. On the CX4-960 power cabling diagram, which does "b" depict?

Which report needs to be run before any maintenance is performed on a CX4 series CLARiiON?

How many BE ports does a CX4-480 array have?

Company.com is using a single user interface. In order to manage multiple CLARiiONs, what must exist?

A customer has a DAE3P configured and running at 4 Gb/s back-end speed, and you install a 2 Gb/s- only drive in the enclosure. What will the DAE3P do with the new drive?

Which protection type is used on the cache vault?

Your customer's CX4-960 array is experiencing boot problems with SPA. You observe that the fault LED for SPA is blinking amber at the rate of four times a second (4 Hz). Where did...

How is the Image Repository area of the CX4 vault disks protected?

How many GB of memory are installed in each CX4-480 SP?

Which four applications can be installed during a CLARalert installation?

Which software needs to be installed to properly configure the CLARiiON Management Station?

How many SPE power supplies are needed to start Write caching on a CLARiiON CX3-20?

The Hardware Maintenance page of the Navisphere Service Taskbar (NST) provides several wizards to aid in maintenance (not in engineering mode). One wizard allows you to upgrade the...

When booting the Utility Partition on a CLARiiON storage processor using a serial connection, what is the proper HyperTerminal Baud Rate used?

Which information Repository area of the CX4 vault sector of a degraded mode RAID 1/0 group?

What is the correct communication protocol between EMC and the EMC ESRS gateway?

It is best practice to place the iSCSI I/O module in the I/O annex first on which CX4 model?

A Customer Engineer is sent to a customer site to replace a storage processor (SP) in a CLARiiON CX4-960 array. What is the proper procedure to follow when replacing this unit?

What is required before performing a CX4 new hardware installation?

Which host failover software is supported with a Non-Disruptive Upgrade (NDU)?

A hot spare should be configured per how many FC drives in an array?

Where is the PSM located in the CLARiiON CX4 series array and how is it protected?

On a CLARiiON CX4-960 array what is the maximum number of drives supported on each back- end loop?

Which RAID levels provide data protection in the CLARiiON?

When retrieving an SPCollect from a CX4 array, what is the location of the files shown in the file transfer manager of the storage processor?

What is the maximum write cache value for a CX4-480 array?

Which CX4 model supports SATA-II drives as vault drives?

How much memory is installed on each CLARiiON CX3-20f SP?

Which utility/command line should be run on a McData switch to collect the data needed to analyze problems?

How many Fibre FE ports are installed in the minimum configuration on a CX4-240 array?

Which CX4 array model has a maximum number of two BE Fibre Channel ports per storage processor (SP)?

When does the PSM activate the new software on the secondary storage processor in a Non- Disruptive Upgrade (NDU)?

A Customer Engineer has been asked to perform an upgrade on a CX4-480 series array by adding a new DAE2P (disk-array enclosure). According to the CLARiiON Procedure Generator, what...

Your customer wishes to zone a Windows host HBA to Storage Processor B port 1 on a CX4-960 array. Which WWPN should be included in the zone?

How many bytes are contained in a physical sector on a SATA disk drive in a CLARiiON array?

Which FLARE log event code indicates data loss has occurred?

How does the factory format CLARiiON Fibre Channel drives to take advantage of the data protection scheme called the "Magic" 8 bytes?

Which tool/utility can be used to locate the LUN ID for the vault?

What does the low priority, always running, Sniff Verify operation check?

Which two items must be set to consider a CLARiiON array fully "initialized" by the Installation Wizard?

Which utility/command line collects the data needed to analyze a Brocade switch?

How many back-end ports are on each CLARiiON CX3-10c SP?

Under which failure scenario, with FLARE 28, will the array maintain cache?

One of the rules fails in Navisphere Service Taskbar (NST) during a FLARE upgrade. You are prompted for a password to override this individual failed rule. Which password is used t...

Your customer wishes to zone a Windows host HBA to Storage Processor B port 9 on a CX4-960 array. Which WWPN should be included in the zone?