E20-611 Exam Questions

Which tool must be used to associate the Host LUN Number (HLU) to the FLARE LUN Number (FLU)?

A CLARiiON has two drives with bad sectors, an FC drive and an ATA drive. How will the two different drive types handle the errors?

Your customer has asked you to explain the RAID 5 parity and striping functions on a CX4 series array. How many stripes will you tell them occur on a disk before the parity block w...

What is NOT a valid feature of proactive hot sparing?

How many UltraFlex I/O module slots are available in a CX4-960 array?

Click the Exhibit button. You have been tasked with performing a Non-Disruptive Upgrade on Your customer's CX4 array. You plan to use Navisphere Service Taskbar (NST) on your servi...

Company.com wants assistance assigning two LUNs to a host. LUN 58 needs to appear to the host before LUN 2. Which value needs to be modified?

Your customer's CX4-240 array is experiencing boot problems with SPA. You observe that the fault LED for SPA is blinking amber at the rate of once every four seconds (1/4 Hz). Wher...

Which parity calculation method does RAID 5 use?

Your customer has experienced problems viewing target LUNs from one of their Windows hosts. The Support Center has requested a data collection. Which EMC supplied utility should be...

What is the maximum number of disk drives supported on each back-end loop of a CLARiiON CX3- 20f array?

When using SPLAT, what is the default log file viewing mode?

Click the Exhibit button. In the illustration, how should the I/O Annex correspond to the SPs from left to right?

How many fans are in a CX4-960 fan pack?

You are working on a CLARiiON where one DAE is streaming 801 errors. You are unable to trace exactly what drive or drives are causing the problem. Which tool would be best to trace...

A disk in a RAID 5 set has failed. While performing the rebuild to the hot spare a permanent CRC sector error is encountered on one of the remaining disks in the RAID group. What i...

Which CX4 array model has a maximum number of one back-end Fibre Channel port per storage processor (SP)?

Which operating systems support EMCRemote?

What are the four main sections contained in the Interactive Installation Guide (IIG)?

Which IP address is required when configuring Centralized monitor Email-Home during the CLARalert ConnectEMC installation?

On CLARiiON Fibre Channel arrays, which type of protection is used on the FLARE Db?

Which type of browser is supported for the Navisphere Interface?

Where do the analyze comments originate from when using the Analyze feature in SPLAT?

Which item does SPCollect contain that is NOT in the navicli getall command?

Company.com is having problems with their environment and Technical Support requests a full data collection using CAP2. Which information will the customer need to supply to collec...

In a CLARiiON array, which software component communicates with Classic Navisphere CLI commands?

What is the main function of the domain master?

Which two requirements are needed to run CAP2?

A RAID 5 group is running in degraded mode. Parity shedding has occurred. What is the status of the RAID group?

The following command was issued: naviseccli h clariion_SPA resetandhold After the command completed, SPA is no longer accessible. Which command will make SPA accessible again?

Which software must be installed for CAP2 to analyze files?

A CLARiiON CX3 SP is executing POST testing. Which frequency is the Fault LED flashing during this time?

A back-end loop of a CLARiiON CX3-80 is running at 2 Gb/s. All enclosures and drives are capable of 4 Gb/s. The following command was issued: naviseccli -h 10.127.94.127 backendbus...

Which three modes are available to view a file in SPLAT?

In the event of a power outage, which local repository keeps a record of the write requests that are currently outstanding?

How many front-end ports are on each CLARiiON CX3-20c SP?

Which function is an aid in identifying the correct enclosure with the failing disk?

Which release added SPCollect to the Navisphere GUI?

Why is zero-disk run during the Enhanced Installation Procedure?

Company.com has forgotten the storage administrative user account password. What is the solution to retrieve the account password?

Which two items does SPCollect contain?

How many front-end FC ports are on each CLARiiON CX3-40f SP?

What are the default Sniff parameters in release 24?

In a CLARiiON array, which software component communicates with Secure CLI commands?

What is a requirement when installing a new CLARiiON array with the Storage System Initialization Wizard?

What is written to the vault drives when a utility power failure occurs?

What is the connection type between the ATA DAE2 midplane and the disk drive?

When would a WebEx session be necessary?

How many back-end ports are on each CLARiiON CX3-20 SP?

You ran Background Verify on a LUN. You received the output as shown in the exhibit. Which option do you have in this situation?