A network engineer needs to remove switch 2 from a stack of four switches permanently. Which procedure should the network engineer use?

Question

Options

• AAdjust the stacking cables to take the N-Series switch out of the stack, log into the CLI of the stack, and run the following command: console#configure console(config)#stack console(config)#no member 2 console(config)#exit console#wr
• BAdjust the stacking cables to take the switch out of the stack. The master switch will automatically remove the switch from the stack.
• CAdjust the stacking cables to take the switch out of the stack, log into the CLI of the stack, and run the following command: console#configure console(config)#stack console(config)#no stack member 2 console(config)#exit console#wr
• DAdjust the stacking cables to take the switch out of the stack, and reboot the stack.

• A
  74% (28)
• B
  5% (2)
• C
  3% (1)
• D
  18% (7)

No community discussion yet for this question.