Dell
DNDNS-200 · Question #75
Refer to the exhibit. A customer installs a non-PoE line card to replace a previously installed PoE line card in slot 0. After unseating the line card, which two commands should a network engineer…
The correct answer is B. console(conf)#remove linecard 0 console(conf)#insert linecard 0. See the full explanation below for the reasoning.
Question
Refer to the exhibit. A customer installs a non-PoE line card to replace a previously installed PoE line card in slot 0. After unseating the line card, which two commands should a network engineer use to prepare the switch to accept the new line card?
Options
- Aconsole(conf)#configure linecard 0 E48TB console(conf)#insert linecard 0
- Bconsole(conf)#remove linecard 0 console(conf)#insert linecard 0
- Cconsole(conf)#configure linecard 0 E48TB console(conf)#remove linecard 0
- Dconsole(conf)#remove linecard 0 console(conf)#configure linecard 0
How the community answered
(29 responses)- A7% (2)
- B76% (22)
- C14% (4)
- D3% (1)
Community Discussion
No community discussion yet for this question.