D-NWG-FN-23 Exam Questions

Refer to the output. A technician implements a new N-Series switch and connects it to another N-Series switch with OSPF already configured. The OSPF neighbor does not show up after...

What accurately describes OSPF?

What is the default MAC address aging time interval for a switch's MAC address table?

Which IPv6 protocol is used by a host to discover the network configuration?

Several PCs are connected together using an Ethernet hub. How does an Ethernet network interface card recognize that a collision has occurred?

Which protocol is capable of routing IPv6 traffic?

When using Dell X-Series or N-Series switches, which two Spanning Tree features provide more efficient convergence? (Choose two.)

Which three services use UDP for data segment transportation? (Choose three.)

A technician enables Dot1x RADIUS authentication globally on all ports on the N2000 switch. All ports show as unauthorized and management access to the switch has been lost. What i...

Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?

Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?

What is a Port Address Translation function?

Refer to the exhibit. A technician is troubleshooting IP connectivity between two servers connected to the same N3024 switch. Server 1 is configured with a gateway of 192.168.1.1 a...

Which security option uses a local username database for switch authentication?

Which port type should be used for only VLAN-unaware devices?

Which IEEE Standard could be used if there is a need to have link redundancy while allowing load balancing between two switches?

Which command configures local authentication for SSH as the primary method?

After reloading a switch, which mechanism is used to recover an OS6 password?

Refer to the output from a Dell N-Series switch: A technician checks the connectivity to the default gateway from the switch and notices the ping fails. At which layer does the pro...

Which statement is true when configuring ACLs?

A Dell Networking N-Series switch is directly connected to a wireless Access Point that requires access to VLANs 1, 10, and 20 configured on the switch. Which two Port VLAN Modes c...

Which Dell EMC Networking N-Series model has 4 x integrated 10GbE SFP+ ports?

Which switching technology can help reduce the size of broadcast domains?

What is the valid range assigned to a client during a TCP connection?

What is the network address for the IP address 10.5.6.73 with subnet mask 255.255.255.192?

Which command defines the possible IP addresses that can be leased to clients using DHCP?

How many broadcast domains are created by an Ethernet switch?

What information is used to define an extended MAC ACL filter?

An Ethernet switch receives a frame from a directly connected host. The source MAC address of the frame is not present in the MAC address table for the switch. However, the destina...

Which two methods will create a VLAN on N-Series switches? (Choose two.)

Refer to the output: A technician creates a new fiber connection to the switch. The transceivers and cable are plugged in at both ends. The connection is in a link down state. What...

What are Network Address Translation (NAT) outside global addresses?

What is the IEEE 802.3 identifier for 100 Mb/s Ethernet over fiber optic cable?

Refer to the exhibit. Two Dell Networking N2000s connected in stack and one Dell Networking N3000 with out of- box configuration are connected as shown. Which additional change mus...

Which message is sent by a router when TTL expires?

Which type of protocol is OSPF and what metric does it use to determine best path?

What is the function of the authentication service?

A customer reports they can no longer access their services and a network administrator has been assigned to investigate. A UFD disabled error status appears on all ports. What cau...

What is an advantage of UFD?

Which best describes traffic flow in a campus network environment?

Which command is used to create a non-default VRF instance?

How does a DHCP Client make a request to a DHCP server following an offer?

Refer to the exhibit. What is the VRRP state of OS10-A after a router with a default VRRP admin priority with VRID100 comes online?

To which IEEE standard are dynamic LAGs compliant on Dell EMC Networking OS10 switches?

When configuring a vrf instance for the management interface that has been in use, what step must be done first to configure it?

Using the MAC 8c-ec-4b-5b-61-9d, what is a valid EUI-64 link local address?

A network administrator is designing a Layer 2 topology and requires separate spanning-tree roots to avoid having a given port blocked for all instances. Which spanning-tree protoc...

Refer to the exhibit. Which configuration will allow S1 to ping S2's Lo0 address?

The network administrator wants to configure RADIUS authentication for VTY access, and for console access to use the local configuration. Which two commands should be used to achie...

There is a spanning tree mismatch at the global level. PVST+ is configured on a VLT peer. All VLT port channels go down on both VLT peers. A syslog error message is generated. What...