CWDP-305 Exam Questions
331 real CWDP-305 exam questions with expert-verified answers and explanations. Page 4 of 7.
- Question #153
After designing and deploying a WLAN infrastructure, you realized the CCI is causing poor performance in the 2.4 GHz band. Primarily, you've designed the WLAN for 5 GHz and 2.4 GHz...
- Question #154
You have performed a validation site survey after deploying a WLAN infrastructure that is an All- Wireless-Office. One specific application of your customer is experiencing delay w...
- Question #155
What are the deliverables to your customer after successfully implementing a WLAN infrastructure?
- Question #156
Who should be in the final meeting from the customer-side after successfully implementing a WLAN infrastructure?
- Question #157
During a validation site survey, you realize that the installers mounted some of the APs above the ceiling. They said that this was a request from the building architect due to aes...
- Question #158
While performing a validation site survey, you realize that overlapping channels are being used on the 2.4 GHz bad due to the automatic channel assignment algorithm of the WLAN inf...
- Question #159
In a convention center, you have received complaints about the WLAN infrastructure. At this moment, the are only two APs in one auditorium. After analyzing the situation, you deter...
- Question #160
What might limit the ability to locate 802.11 clients using a WLAN infrastructure without an 802.11 tag? (Choose all that apply.)
- Question #161
While performing a validation site survey, you realize that overlapping channels are being used on the 2.4 GHz bad due to the automatic channel assignment algorithm of the WLAN inf...
- Question #162
Which of the following items could be considered constraints when performing a network design? (Choose all that apply.)
- Question #163
As a device starts to shift to lower PHY rates, what factors usually influence a device decision to shift to lower PHY rates? (Choose all that apply.)
- Question #164
Before performing a pre-deployment passive RF survey of a new deployment using survey mapping software, which of the following must be performed?
- Question #165
What type of standards-based encryption is used by office extension APs for the traffic tunnel? (Choose all that apply.)
- Question #166
What functions may be performed by a WIPS? (Choose all that apply.)
- Question #167
In your company's WLAN, you expect to have a mixed client PHY environment and plan to use protection mechanisms. The protection mechanism used by your client devices is configurabl...
- Question #168
A table of VLANs in a _________ document should include what device performs ________ services. (Fill in the blanks)
- Question #169
A business traveler from North America is in Europe. The hotel only provides coverage in 2.4 GHz. The traveler connects to the hotel's SSID and notices an AP in the hotel room. How...
- Question #170
During lunch time in the break room of a company, Wi-Fi connectivity on the 2.4 GHz band is intermittent. Every other time of the day, it works fine. What's the likely cause of thi...
- Question #171
A museum wants to offer Wi-Fi to its visitors. One of their requirements is to have the APs blend into the design of the museum. What should you do to meet this requirement?
- Question #172
An MSA commonly addresses at least which two legal categories?
- Question #173
For what purpose is SSID hiding generally useful? (Choose all that apply.)
- Question #174
SSID hiding is not generally recommended because some frames require inclusion of the SSID. In what frames is the SSID always included?
- Question #176
When viewing channel utilization information from a protocol analyzer, if high channel utilization is occurring, what should you ensure does not exist?
- Question #177
A cable with 2.5 dB of loss is used to measure the return loss of an antenna. The measured value in- band is shown to be larger than 20 db. What is the actual return loss of the an...
- Question #178
What statements are true regarding jitter and latency? (Choose all that apply.)
- Question #179
For what purposes are VPNs typically used in modern WLANs? (Choose all that apply.)
- Question #180
What differences exist between VLANs in wireless and wired domains?
- Question #181
An enterprise customer is subject to the highest standards for network uptime. When designing their wireless network, you should consider which of the following? (Choose all that a...
- Question #182
Four buildings are located in a square orientation to each other. Fisch Stix Food Company is requesting a PtMP link between the buildings. On the building with the root bridge link...
- Question #183
What are some common problems with short (12 or fewer characters) ASCII passphrases in WPA/WPA2-Personal networks?
- Question #184
What advantages are provided by per-user PSKs when compared with ESS-wide PSKs? (Choose all that apply.)
- Question #185
Modulation can be defined as:
- Question #186
Left to its simplest form, what method does a location algorithm use to determine location within a WLAN coverage area?
- Question #187
Which of the following is not a business requirement?
- Question #188
The thermal noise is at -174 dBm/Hz. A spectrum analyzer has a resolution bandwidth of 1 kHz and a 5 dB noise figure. What is the level of the noise floor?
- Question #189
What operational plane would a WNMS primarily interact with?
- Question #190
In the enterprise, when is WPA/WPA2-Personal generally a recommended solution? (Choose all that apply.)
- Question #191
How are EAP messages transported over 802.11 wireless LANS?
- Question #192
NicoCo is building a new facility and would like to install a WLAN for primary connectivity of all clients. The requirements are dual-spectrum 802.11n supporting voice and location...
- Question #193
What factors are key features when designing a guest network for a large enterprise? (Choose all that apply.)
- Question #194
In an RSN requiring low-latency reassociations and no fast secure roaming protocols, what security solutions are ideal for protecting VoWiFi communication? (Choose all that apply.)
- Question #195
For what types of systems should you request read-only access to in order to perform an analysis of the customer's existing infrastructure? (Choose all that apply.)
- Question #196
What is the chip rate of 1 Mbps 802.11b?
- Question #197
What strategy can be used to ensure efficient cell overlap for VoIP site surveys?
- Question #198
During a post-validation assessment, you have configured a client for 802.1X/EAP but it is not passing authentication. Which areas should you check in the WLAN configuration?
- Question #199
A high power radio system transmits at 40,000 Watts. What is this power in dBm? Solve this without a calculator.
- Question #200
One of your warehouse customers called you reporting problems with their WLAN in some locations that you designed and installed over a year ago. What should be one of your first co...
- Question #201
When designing for a PTP outdoor link, what important consideration should be made about local vegetation? (Choose all that apply.)
- Question #202
What are methods of providing RF high availability?
- Question #203
What two 802.11 amendments deal with regulatory and transmission requirements?