Microsoft
70-649 · Question #332
Your network contains a server named Server2 that runs Windows Server 2008 R2 Service Pack 1 (SP1). Server2 has the Hyper-V server role installed. The disks on Server2 are configured as shown in the e
The correct answer is A. On VM1, add a virtual hard disk (VHD) to an IDE controller. F. Take Disk 2 offline.. See the full explanation below for the reasoning.
Question
Your network contains a server named Server2 that runs Windows Server 2008 R2 Service Pack 1 (SP1). Server2 has the Hyper-V server role installed. The disks on Server2 are configured as shown in the exhibit. (Click the Exhibit button.) You create a new virtual machine (VM) named VM1. You plan to install Windows Server 2008 R2 SP1 on VM1. You need to configure Disk 2 on Server2 as the system drive of VM1. Which two actions should you perform? (Each correct answer presents part of the solution. Choose two.)
Exhibit
Options
- AOn VM1, add a virtual hard disk (VHD) to an IDE controller.
- BOn VM1, add a virtual hard disk (VHD) to an SCSI controller.
- CConvert Disk 2 to a dynamic disk.
- DOn VM1, add a physical hard disk to an SCSI controller.
- EOn VM1, add a physical hard disk to an IDE controller.
- FTake Disk 2 offline.
- GConvert Disk 2 to a GPT disk.
How the community answered
(30 responses)- A73% (22)
- B3% (1)
- C3% (1)
- D13% (4)
- E7% (2)
Community Discussion
No community discussion yet for this question.