6102 Exam Questions
64 real 6102 exam questions with expert-verified answers and explanations. Page 1 of 2.
- Question #1
A customer is concerned about the security of their network. They need to understand the OSPF authentication options when accepting route updates in OSPF. Currently, their Virtual...
- Question #2
The following ACLI commands are used to set up an MLT on the Virtual Services platform (VSP) 9000 and the last command in this sequence produces an ACLI error. VSP-9012:1 (config)...
- Question #3
A customer is expressing concern about reliability for their single uplink connections to the wiring closet. The switches in the wiring closet support Distributed Multi link Trunki...
- Question #4
A customer has an Avaya Media Gateway connected to a virtual services Platform (VSP) 9000. The IP telephones are connected to legacy access switches only supporting 802.1p. Avaya 6...
- Question #5
In a fully populated Virtual Services Platform (VSP) 9000 with 10 I/O modules, what is the required number of Switch Fabric (SF) modules to allow full throughput?
- Question #7
What conclusion can be drawn from the output in the exhibit?
- Question #8
What must be done, before the SNMPv3 can be used with Data encryption Standard (DES) or Advanced Encryption Standard (At S) to across the device?
- Question #9
A technician has opened Enterprise Device Manager (EDM) and observed the status of the Virtual Services Platform (VSP) 9000 port 3/12. What does the color red indicate?
- Question #10
Which ACLI command is used to allow the non-secure (HTTP) web interface?
- Question #11
A technician is successful when using the ping command on a Virtual Services Platform (VSP) 9000 to the peer VSP 9000 configured as a switch cluster. The IST is operating correctly...
- Question #12
A Virtual Services Platform (VSP) 9000 with dual CP modules is not communicating with both of the out of band management ports. What is the single issue identified as the problem?
- Question #13
In an environment with Dynamic VI ANs (policy-based) once a classification rule hits, allowed membership is checked. If the port is not allowed, what will happen to the frame?
- Question #14
A technician has enabled VLACP on the IST connection, and wants, to verify that is operating Avaya 6102 Exam properly. When using the show vlacp interface command, what is the time...
- Question #15
Avaya Command Line Interface (ACLI) is an industry standard CLI that can be used to manage the virtual Services Platform (VSP) 9000. Of the five major CLI command modes, which mode...
- Question #16
In the current business environment everyone is being asked to do more with fewer physical resources. Using visualization allows the Virtual Services Platform (VSP) 9000 to initiat...
- Question #17
Given the following message that is seen in the log file: CPU1 [11/16/10 16:13:29.367\] 0x000eO5f1 00000000 GlobalRoutor HAL INFO SMLT port 3/17/ locked until IST comes up. To forc...
- Question #19
A Virtual Services Platform (VSP) 9000 chassis will need to terminate the following connections: four 10GbE: 10GBaseER core connections in a redundant DMLT configuration 80 GbE 100...
- Question #20
Given the following command: VSP-9012: 1$ show khi performance <cmd> slot Which Key Health Indicator is only valid for the CP modules?
- Question #21
How many 9080CP modules can be installed into a single chassis?
- Question #22
Given the following ACL applied to an interface: filter acl ace 1 5 name "xxxx" filter acl ace action 1 5 deny filter acl ace ip 1 5 ip-protocol-type eq tcp filter acl ace protocol...
- Question #23
Internet Group Management Protocol (IGMP) is used by the IP Multicast router, to learn about the existence of host group members on their directly attached subnets. Which statement...
- Question #24
A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Virtual Services Platform (VSP) 9000 core. The technician needs to configure VRF o...
- Question #26
Avaya recommends that the Switch Fabric (SF) modules be installed in both Slot SF1 and Slot SF4. What is the reason behind this recommendation?
- Question #27
A support engineer will use the EDM web-based embedded element management tool to support the Virtual Services Platform (VSP) 9000 configuration management. Which ACLI configuratio...
- Question #28
The information in the exhibit is displayed on the console of one of the Virtual Server Platforms (VSPs) 9000 in a switch cluster. Avaya 6102 Exam When is the information in the ex...
- Question #29
A customer has a stack of Ethernet Routing Switch (ERS) 5698TFD switches, the uplinks to the network core are via two Gigabit uplink ports from the first ERS 5698TFD in the stack t...
- Question #30
Which statement about the local router MAC addresses on RSMLT aggregation switches (cluster) is true?
- Question #31
The Chassis Area Network (CAN) uses the SERDES to connect which modules in the Virtual Services Platform (VSP) 9000?
- Question #32
Which statement describes a characteristic of Routed Split Multilink Trunking (RSMLT) configuration?
- Question #33
A switch cluster core composed of two Virtual Services Platform (VSP) 9000 switches has been properly configured to support a new edge switch stack. 802.1Q was not correctly config...
- Question #34
Which file on the internal flash is used to specify the primary and backup release names?
- Question #35
The Virtual Services Platform (VSP) 9000 chassis has 12 slots in the front and 8 slots in the back. Two front slots are for the Control Processor (CP) modules and 10 front slots ar...
- Question #36
A technician has entered the ACLI show tech command on a Virtual Services Platform (VSP) 9000 and found a fan fault. What is true about this fan fault in the chassis?
- Question #37
Network virtualization is the process of combining hardware and software network resources into a single virtual network. Which two customer scenarios are appropriate for virtualiz...
- Question #38
Policy based traffic policers and traffic shapers identify traffic using a policy (a contract). Traffic that confirms to this policy (a service contract) is guaranteed transmission...
- Question #39
Which multicast technology, used with the Virtual Services Platform (VSP) 9000, allows the router to determine whether any group members exist on its directly connected networks an...
- Question #40
Which statement describes how to configure Simple Loop Prevention protocol (SLPP) Rx?
- Question #41
SMLTv2 is introduced with the Virtual Services Platform (VSP) 9000 and is easier to configure than SMLTv1. What is a requirement for SMI Tv2?
- Question #42
How many cooling modules does a Virtual Services Platform (VSP) 9000 chassis have?
- Question #43
The Virtual Services Platform (VSP) 9000 supports several types of I/O modules. Which ports does the 9048GT contain?
- Question #44
A technician has received a now Virtual Services Platform (VSP) 9000 with four IO modules, two CPU modules, six Switch Fabric (ST) modules and six power supplies. What is the recom...
- Question #45
Simple Loop Prevention Protocol (SLPP) provides active protection against layer 2 network loops on a per-VLAN basis. For the SLPP Tx process, the network administrator decides on w...
- Question #46
ACLI is an industry standard CLI that can be used for device management on the Virtual Services Platform (VSP) 0000. Which two statements about ACLI default users are true? (Choose...
- Question #47
Which kind of external memory can be used with the 9080CP modules?
- Question #48
The Virtual Services Platform (VSP) 9000 has several tools that can be used to configure the switch. Which tool uses SNMP to configure the VSP 9000?
- Question #49
An access port is removed from the VLAN to which it belonged. What will happen to this port?
- Question #51
Which three are secure protocols that Virtual Services Platform (VSP) 9000 supports? (Choose three)
- Question #52
A network is using SMLT based switch clustering in a square topology. The network design needs to control the amount of broadcast traffic and protect the CPU from being flooded by...
- Question #53
A technician has configured SLPP on the core switches, and needs to verify that the RX function has been configured correctly. Which command can be used, and on which ports can it...
- Question #54
QoS is the ability to manage the performance of data flows by giving treatment to the data flows, users, and applications. For which two network problems would QoS be a good soluti...