350-601 · Question #210
An engineer must generate a checkpoint of the running configuration on a Cisco Nexus Switch. The checkpoint file name must be called "before_maintenance' and should be used for recovering the switch…
The correct answer is B. checkpoint file before_maintenance D. rollback running-config file before_maintenance atomic. nce/security/n5k-sec-cr/n5k-sec_cmds_r.html rollback checkpoint is invalid command. Rollback should be to running configuration, not a rollback can be selected by a name or file name. the difference between them is using the "file"
Question
An engineer must generate a checkpoint of the running configuration on a Cisco Nexus Switch. The checkpoint file name must be called "before_maintenance' and should be used for recovering the switch to its pre-maintenance state. The rollback of the checkpoint to running configuration should only occur if no errors occur. Which two configuration commands must be used to meet these requirements? (Choose two.)
Options
- Arollback checkpoint file before_maintenance stop-at-first-failure
- Bcheckpoint file before_maintenance
- Ccheckpoint before_maintenance
- Drollback running-config file before_maintenance atomic
- Erollback running-config checkpoint before_maintenance
How the community answered
(16 responses)- B81% (13)
- C6% (1)
- E13% (2)
Explanation
nce/security/n5k-sec-cr/n5k-sec_cmds_r.html rollback checkpoint is invalid command. Rollback should be to running configuration, not a rollback can be selected by a name or file name. the difference between them is using the "file"
Topics
Community Discussion
No community discussion yet for this question.