Which access point mode allows a supported AP to function like a WLAN client would, associating and identifying client connectivity issues?

Question

Options

• Aclient mode
• BSE-connect mode
• Csensor mode
• Dsniffer mode

• A
  4% (1)
• B
  4% (1)
• C
  92% (22)

Explanation

Sensor mode enables a supported access point to operate as a WLAN client, actively probing the network and simulating the client experience to identify connectivity issues such as association failures, authentication problems, and DHCP errors. This makes it invaluable for troubleshooting client-side problems from the network's perspective.

• Client mode (A) is incorrect because, while it sounds similar, "client mode" in Cisco terminology refers to an AP acting as a wireless bridge/client to connect a wired network segment - it is not specifically designed for diagnosing client connectivity issues.
• SE-Connect mode (B) is incorrect because this mode dedicates the AP to work with Cisco Spectrum Expert software for spectrum analysis, focusing on RF interference rather than client connectivity simulation.
• Sniffer mode (D) is incorrect because sniffer mode turns the AP into a passive packet capture device that forwards 802.11 traffic to a protocol analyzer (like Wireshark), rather than actively simulating client behavior.

Memory tip: Think of "sensor" as a synthetic user - it senses what a real client would experience by actually behaving like one, actively testing connectivity end-to-end.

No community discussion yet for this question.