350-050 Exam Questions

Which authentication method is not supported when using the local RADIUS server feature of an autonomous AP?

Refer to the exhibit. Given this debug output from the debug wlccp wds mn command, which event has occurred?

Refer to the exhibit. This portion of a Cisco IOS AP configuration refers to a multiple SSID and VLAN configuration. Which statement is false?

When you set up an 802.11n-capable network using autonomous APs, which two settings let you achieve 802.11n rates? (Choose two.)

You want to prevent a wireless client with a MAC address of 00:40:96:a5:b5:d4 from associating with an autonomous AP. Which commands do you use on the autonomous AP?

Which set of steps shows the correct order for adding an SSID with WPA security on a new VLAN via the GUI on an autonomous AP?

What is the function of the distance command on an autonomous 802.11 bridge?

Which command can you use to configure the standalone AP to use the NTP server at IP address 192.168.1.99?

When configuring multiple BSSIDs in autonomous APs, which three requirements and guidelines should you follow? (Choose three.)

Which debug command is best to use when you suspect that a client will not connect to an autonomous AP because of an incorrect WPA PSK?

Refer to the exhibit. You are troubleshooting a client that is not able to associate to an SSID configured on an autonomous AP. What is most likely the cause of the association fai...

You are setting up a wireless network using autonomous APs. Which two statements are true? (Choose two.)

Refer to the exhibit. You have setup an autonomous AP and configured an SSID to serve clients. While troubleshooting a client that is not able to associate to the SSID, you enable...

To have the CleanAir feature merge reports from APs from different controllers, what do you need?

Refer to the exhibit. Client stations are trying to associate to a given SSID and fail to do so for some time before associating successfully. Considering the debug output that was...

What is the correct procedure to install a chained certificate (if multiple certification authorities are involved) when you do web authentication on a WLC?

When configuring NAC in-band to work with a Cisco WLC, which statement is true, from a WLC perspective?

You have four Cisco WLCs and have deployed wired guest access, using a single guest VLAN for all controllers. How can you achieve redundancy if the guest VLAN fails on the infrastr...

You are on the U.S. East Coast (EST time zone, UTC-5) and configure NTP on your Cisco WLC. The Cisco WLC web GUI shows the correct time and date, but your APs are off by 5 hours. W...

Which three statements about the VideoStream feature (also known as MediaStream) on the Cisco WLC are true? (Choose three.)

What is the minimum number of rules that is necessary in a CPU ACL to allow all access from a single VLAN to the management interface, yet prevent management access from all other...

Refer to the exhibit. Your manager has asked you to configure a remote office Cisco WLC to support local EAP authentication. The manager wants the clients to use EAP-FAST. The LDAP...

A wireless network administrator needs to limit guest user TCP traffic to no more than 50,000 kb/s, to conserve bandwidth on the guest WLAN. To do this, the administrator configure...

Refer to the exhibit. You are a senior wireless network administrator and have just completed the configuration of TACACS+ on your production Cisco WLC server. You can successfully...

After performing a wireless site survey, you determine that to achieve proper HR-DSSS coverage within the rooms along a hallway area, the AP radios that service the hallway must be...

Refer to the exhibit. You are testing coverage-hole detection in your lab. You are using the default Cisco WLC coverage-hole detection configuration that is shown. You have 14 test...

A wireless ISP has hired you to help set up a new Cisco WLC to provide wireless access to subscription-based customers. Each customer that uses the wireless network needs to pay th...

When is the Poor Link SNR Alarm generated in a mesh network?

A 7-Mb multicast traffic stream is being sent to wireless clients and it is using up most of the available wireless spectrum in the 2.4-GHz unlicensed band. As a result, many of th...

The helpdesk is reporting that many users are reporting slow wireless connections in one of the office buildings. You look at the CleanAir statistics and do not see any interferers...

Which two statements about virtual interfaces on a WLC are true? (Choose two.)

Refer to the exhibit. Which EAP type does the diagram illustrate?

Which statement describes the operation of an access point in Rogue Location Discovery Protocol mode?

Refer to the exhibit. You want to use 3500e APs to setup an indoor mesh deployment. After you change the AP mode, the AP will not rejoin the Cisco WLC. Which debug command was run,...

When you configure channel bonding on your APs by using the 2.4-GHz radio, what is the maximum number of APs that you can place in a given location so that the AP channels do not o...

You calculate that your AP should transmit at 6 dBm to provide appropriate wireless coverage, while still complying with EIRP, with the antennas that you selected. However, the AP...

AP A is in AP group ONE and AP B in is AP group TWO. AP group ONE assigns the interface Marketing to the corporate WLAN, whereas AP group TWO assigns the interface Sales to the sam...

What does disabling broadcast SSID in the WLAN configuration do?

What does RLDP do?

You are designing a wireless guest anchoring solution for a large company. Forty-five Cisco WLCs running 7.0.116.0 code are deployed in the corporate network. You expect about 3000...

Refer to the exhibit. Two Cisco WLCs on a Cisco WiSM and in the same mobility group are both running 4.2.209.0 code. All the WLANs on both Cisco WLCs are configured for H-REAP loca...

You are going to create a new WLAN on your production 5508 WLC running 7.0.116.0 code. You do not want this WLAN to be in the default AP group on the Cisco WLC until you have thoro...

Refer to the exhibit. You have just configured multicast on the wired network and the controller. You configured the multicast address on the Cisco WLC to be 239.0.1.25, with IGMP...

Where is Ethernet bridged traffic terminated in a mesh network?

Which two statements about the CleanAir and AP modes are true? (Choose two.)

What is the MAPs behavior if you enable mesh ethernet-bridging vlan-transparent on them?

Which statement about the beamforming (ClientLink) feature on the Cisco WLC is true?

You are running 7.0.116.0. Connecting wireless clients have an HTTP proxy server configured and need to get web redirected in a web authentication (guest) SSID. Which two statement...

To improve the overall wireless experience of your users, you do not want any clients to use 802.11b data rates to associate to your wireless network. You do not want 802.11a/g/n d...

After a scheduled downtime of your 5508 WLC, you notice that only a handful of the 100 APs are rejoining the controller. All the APs are in the same subnet and use default settings...