300-630 Exam Questions
116 real 300-630 exam questions with expert-verified answers and explanations. Page 3 of 3.
- Question #109
A Cisco ACI fabric is configured with these settings: - A single VRF exists that contains 100 EPGs. - EPGs 1 to 50 must be permitted to communicate. - EPGs 51 to 100 must NOT be al...
- Question #110
An engineer configures Cisco ACI Multi-Site and must specify the control plane TEP IP for spines. Which statement describes control plane TEP IP in this situation?
- Question #111
Refer to the exhibit. Server S1 is connected to Cisco ACI using two NIC interfaces. NIC1 is an active interface and NIC2 is a standby interface. NIC2 uses its MAC address to send t...
- Question #112
Which requirement applies to migration from Cisco NX-OS mode to Cisco ACI mode with Cisco Nexus 9000 Series Switches?
- Question #113
What are two PBR characteristics of the Cisco ACI Active-Active Across Pods deployment mode in Cisco ACI Multi-Pod design? (Choose two.)
- Question #114
A Cisco ACI fabric is connected to a switched network that runs Spanning Tree Protocol on VLAN 101. VLANs 101, 102, and 103 are mapped to bridge domain BD10123. The leaf node that...
- Question #115
What is a characteristic of a stretched bridge domain solution between Cisco ACI sites with Layer 2 flood enabled?
- Question #116
Refer to the exhibit. The external subnet and internal EPG1 must communicate with each other, and the L3Out traffic must leak into the VRF named "VF1". Which configuration set acco...
- Question #117
What is the purpose of enabling ARP flooding when VMs are migrated from a pre-existing network to Cisco ACI and their gateways remain configured in the legacy setup?
- Question #118
Refer to the exhibit. Server A is connected to the Cisco ACI fabric using two teamed interfaces. One interface in a team is configured as active and the other remains in standby mo...
- Question #119
Refer to the exhibit. A company decided to decrease its routing footprint and remove RT-2 and RT-3 devices from its data center. Because of that, the exit point must be created fro...
- Question #120
Refer to the exhibit. Which configuration set must be applied to filter 1 to enable SSH communication between Web_EPG to App_EPG?
- Question #121
The engineer notices frequent MAC and IP address moves between different leaf switch ports. Which action prevents this problem from occurring?
- Question #122
Refer to the exhibit. Which type of design approach is shown?
- Question #123
Which protocol must be applied between the inter-pod network and spines within each pod to allow broadcast traffic replication between Cisco ACI pods?
- Question #124
How is the traffic directed to the firewall pair in a two-site Multi-Pod deployment with an active/standby firewall pair stretched across pods?