An engineer configures Cisco ACI Multi-Site and must specify the control plane TEP IP for spines. Which statement describes control plane TEP IP in this situation?

Question

Options

• AThe unique IP address is defined on each spine node that belongs to a fabric and is used to
• BThe unique IP address is defined on each spine node that belongs to a fabric and is used to
• CThe common anycast address is shared by all the spine nodes in the same site and is used to
• DThe common anycast address is shared by all the spine nodes at the same site and is used to

• A
  81% (30)
• B
  11% (4)
• C
  5% (2)
• D
  3% (1)

Explanation

The control plane TEP (Tunnel Endpoint) IP address is a unique IP address assigned to each spine node within a Cisco ACI fabric. This IP address is used to establish MP-BGP EVPN (Multiprotocol Border Gateway Protocol Ethernet VPN) and VPNv4 (VPN version 4) adjacencies with the spine nodes in remote sites when configuring Cisco ACI Multi-Site. The control plane TEP IP enables the spine nodes to exchange routing information and network reachability for seamless integration of multiple sites into a single ACI fabric.

No community discussion yet for this question.