300-430 · Question #236
A network engineer is configuring a Cisco AireOS 8.2 WLC, Cisco MSE, and Cisco PI with Cisco 3700 Series APs and Cisco Hyperlocation modules. The engineer configures and enables a WLAN with Hyperlocat
The correct answer is B. Enable Hyperlocation in the Global Configuration settings of the WLC.. Choose Wireless > Access Points > Global Configuration. In the Hyperlocation Config Parameters section: Check the Enable Hyperlocation check box. Based on AP and installed module, checking the Enable Hyperlocation check box enables different location service (PRL-based or AoA-bas
Question
A network engineer is configuring a Cisco AireOS 8.2 WLC, Cisco MSE, and Cisco PI with Cisco 3700 Series APs and Cisco Hyperlocation modules. The engineer configures and enables a WLAN with Hyperlocation. During testing, the engineer notices that the Hyperlocation module cannot be seen on the WLC. Which action resolves the issue?
Options
- AConfigure the APs to be in monitor mode.
- BEnable Hyperlocation in the Global Configuration settings of the WLC.
- CAdd the key hash that is used to add the Hyperlocation module to the WLC.
- DEnable the NTP server that is connected to the Hyperlocation module.
How the community answered
(35 responses)- A6% (2)
- B74% (26)
- C6% (2)
- D14% (5)
Explanation
Choose Wireless > Access Points > Global Configuration. In the Hyperlocation Config Parameters section: Check the Enable Hyperlocation check box. Based on AP and installed module, checking the Enable Hyperlocation check box enables different location service (PRL-based or AoA-based). guide/b_cg82/b_cg82_chapter_011010.html#config-hyperlocation- global:~:text=Check%20the%20Enable%20Hyperlocation%20check%20box.
Topics
Community Discussion
No community discussion yet for this question.