300-415 Exam Questions

Which device information is required on PNP/ZTP to support the zero touch onboarding process?

Which configuration step is taken on vManage after WAN Edge list is uploaded to support the onboarding process before the device comes online?

Which SD-WAN component is configured to enforce a policy to redirect branch-to-branch traffic toward a network service such as a firewall or IPS?

Which command verifies a policy that has been pushed to the vEdge router?

Which policy configures an application-aware routing policy under Configuration > Policies?

A voice packet requires a latency of 50 msec. Which policy is configured to ensure that a voice packet is always sent on the link with less than a 50 msec delay?

When VPNs are grouped to create destination zone, how many zones can a VPN be part of?

Which scheduling method is configured by default for the eight queues in the cloud vEdge router?

At which layer does the application-aware firewall block applications on a WAN Edge?

Refer to the exhibit. Which QoS treatment results from this configuration after the access list acl-guest is applied inbound on the vpn1 interface? policy policer ccnp rate 1000000...

Which configuration changes the packet loss priority from low to high?

Which software security feature is supported by the Cisco ISR 4451 router?

Which two mechanisms are used to guarantee the integrity of data packets in the Cisco SD-WAN architecture data plane? (Choose two.)

Which value is verified in the certificates to confirm the identity of the device?

Which hardware component is involved in the Cisco SD-WAN authentication process for ISR platforms?

Which component of the Cisco SD-WAN architecture oversees the control plane of overlay network to establish, adjust, and maintain the connections that form the Cisco SD-WAN fabric?

Which two hardware platforms support Cisco IOS XE SD-WAN images? (Choose two.)

What is a default protocol for control plane connection?

Which component of the Cisco SD-WAN control plane architecture should be located in a public Internet address space and facilitates NAT-traversal?

Which Cisco SD-WAN WAN Edge platform supports LTE and Wi-Fi?

Refer to the exhibit. What does the BFD value of 8 represent? Hostname State System IP Reachability Site ID Device Model BFD Control BR1-VEDGE1 10.3.0.1 reachable 300 vEdge Cloud 8...

Which command disables the logging of syslog messages to the local disk?

Which platforms are managed by a single vManage dashboard?

Which alarm setting is configured to monitor serious events that affect, but do not shut down, the operation of a network function?

Which pathway under Monitor > Network > Select Device is used to verify service insertion configuration?

What is the default interval for BFD packets?

Which two options are SD-WAN solution capabilities? (Choose two.)

Which two platforms for the Cisco SD-WAN architecture are deployable in a hypervisor on-premises or in IAAS Cloud? (Choose two.)

How is the scalability of the Manage increased in Cisco SD-WAN Fabric?

Which component of the Cisco SD-WAN control plane architecture facilitates the storage of certificates and configurations for network components?

An engineer is troubleshooting a vEdge router and identifies a "DCONFAIL ?DTLS connection failure" message. What is the problem?

An engineer is troubleshooting a control connection issue on vEdge. Which command is used to verify the validity of the certificates?

Refer to the exhibit. An engineer is troubleshooting a control connection issue. What does "connect" mean in this show control connections output?

A vEdge platform is sending VRRP advertisement messages every 10 seconds. Which value configures the router back to the default timer?

Which OSPF command makes the WAN Edge router a less preferred exit from a site with a dual WAN Edge design?

Drag and drop the vManage policy configuration procedures from the left onto the correct definitions on the right.

Drag and drop the actions from the left into the correct sequence on the right to create a data policy to direct traffic to the Internet exit.

When redistribution is configured between OMP and BGP at two Data Center sites that have Direct Connection Interlink, which step avoids learning the same routes on WAN Edge routers...

Which statement about VRRP is true?

Where does the Cisco V-Edge Router perform QOS traffic classification?

On which device is a service FW address configured to insert firewall service at the hub?

Which attributes are configured to uniquely identify and represent a TLOC route?

Which type of route advertisement of OMP can be verified?

Which command displays BFD session summary information per TLOC on vEdge routers?

Which configuration allows users to reach YouTube from a local Internet breakout?

Which feature template configures OMP?

Two sites have one WAN Edge each. Each WAN Edge has two public TLOCs with no restrict configured. There is full reachability between the TLOCs. How many data tunnels are formed on...

Which command on a WAN Edge device displays the information about the colors present in the fabric that are learned from vSmart via OMP?

In which VPN is the NAT operation on an outgoing interface configured for direct Internet access?

Which API call retrieves all a list of all devices in the network?