Cisco
300-415 · Question #33
300-415 Question #33: Real Exam Question with Answer & Explanation
The correct answer is D: Control connection is connected. In the show control connections output, the 'connect' state signifies that the control plane connection between the vEdge router and the vSmart controller is fully established and operational.
Management and Operations
Question
Refer to the exhibit. An engineer is troubleshooting a control connection issue. What does "connect" mean in this show control connections output?
Options
- AControl connection is down
- BControl connection is up
- CControl connection attempt is in progress
- DControl connection is connected
Explanation
In the show control connections output, the 'connect' state signifies that the control plane connection between the vEdge router and the vSmart controller is fully established and operational.
Common mistakes.
- A. If the control connection were down, the state would typically be 'down' or 'disconnect'.
- B. While 'up' is technically correct, 'connected' more precisely describes the specific keyword shown in the output, implying full establishment.
- C. A connection attempt in progress would typically be indicated by states like 'connecting' or 'init', not 'connect'.
Concept tested. Interpreting SD-WAN control connection states
Topics
#SD-WAN Control Plane#Troubleshooting#Command Output Interpretation#Operational Status
Community Discussion
No community discussion yet for this question.