300-070 Practice Questions
414 real 300-070 exam questions with expert-verified answers and explanations. Page 2 of 9.
- Question #51
Which four modes are available on the Cisco TelePresence MCU MSE 8510 to connect to a gatekeeper? (Choose four.)
- Question #52
Which two Cisco products allow the use of a dial plan with E.164, H.323, SIP, and DNS? (Choose two.)
- Question #53
Refer to the exhibit. To reach an external number, a user first dials a 9. Which route pattern will be matched if a user dials the toll-free number 18005550123?
- Question #54
Refer to the exhibit. When a user dials 919005551212, the call fails. Which change do you need to make for this call to be successful?
- Question #55
Where do you configure a SIP route pattern?
- Question #56
Refer to the exhibit and configuration output. What are the two main ways from New York to call Extension 6001 in England? (Choose two.) sh run | s Dial-peer dial-peer voice 2 voip...
- Question #57
Refer to the exhibit. Which party has a SIP B2BUA role in the call?
- Question #58
Which three commands show the output of an active video call? (Choose three.)
- Question #59
What are two characteristics that are associated with the End User and User account types? (Choose two.)
- Question #60
Which two features are advantages of deploying a cluster over WAN? (Choose two.)
- Question #61
The Ajax Corporation is designing an IP telephony network using Cisco MCS 7845 Series servers, each one capable of supporting 7500 devices. The design must meet these requirements:...
- Question #62
What is the relationship between a Region and a Location?
- Question #63
How are Cisco Unified CallManager location parameters used?
- Question #64
Which statement regarding Cisco IP voice media streaming application is correct?
- Question #65
Which two codecs are required for Cisco WebEx Enabled TelePresence? (Choose two.)
- Question #66
What is the correct path selection for a call that is routed through a Cisco Unified Communications Manager system?
- Question #67
Which configuration output indicates a properly configured T1 digital voice interface?
- Question #68
Refer to the exhibit. A Cisco Unified Communications Manager group is configured with the subscriber (10.1.5.3) listed first and the publisher (10.1.5.2) listed second. Which Cisco...
- Question #69
Which three statements about the default VoIP dial peer are true? (Choose three.)
- Question #70
Refer to the exhibit and configuration output. A user in New York (5001) is trying to call a user in London (6001), but the call cannot be completed. Assuming that the WAN uplink i...
- Question #71
You are a Voice Engineer at ABC Company. You want to implement a voice translation profile to perform the following manipulation: The incoming DNIS 9876562XXX should be modified to...
- Question #72
On what equipment do you configure Layer 2 to Layer 3 QoS mapping?
- Question #73
Which mechanism is often configured on the edges of a network to control the maximum rate of traffic that is sent or received on an interface and to classify the traffic into prior...
- Question #74
Which three characteristics of a video stream require the implementation of QoS? (Choose three.)
- Question #75
Which two statements about Cisco VCS Addressing Zones are true? (Choose two.)
- Question #76
Which four call coverage features are used by voice gateways? (Choose four.)
- Question #77
Which three CLI commands allow you to verify the correct VoIP dial-peer matching? (Choose three.)
- Question #78
Which three of these are characteristics of a Cisco Unified Communications Manager software- based Media Termination Point? (Choose three.)
- Question #79
Which option describes how you add software conference bridges to Cisco Unified Communications Manager?
- Question #80
Which of these media resources can be configured in Cisco Unified Communication manager? (Choose Three)
- Question #81
What are two characteristics of a Cisco Unified Communications Manager dial plan? (Choose two.)
- Question #82
What are two characteristics of a Cisco Unified Communications Manager Express dial plan? (Choose two.)
- Question #83
When comparing SIP H.323 and MGCP, which of the following is specific to SIP?
- Question #84
Every VoIP endpoint must select one specific codec. Which of these codecs is the mandatory codec?
- Question #85
Refer to Exhibit, If the user at extension 1001 dials the user at extension 2011, which dial peer is used to route the call?
- Question #86
If you have configured translation rules, what command do you use to verify digit manipulation?
- Question #87
Which two options are IOS conference bridge types in CUCM? (Choose two)
- Question #88
Which distribution algorithm is used for a route group?
- Question #89
A Cisco Unified Communications Manager group specifies a prioritized list of how many Cisco Unified Communications Managers?
- Question #90
You are a Voice Engineer at ABC Company. You want to provision a new voice gateway for a remote site, and you need to configure 24 channels of a T1 CAS interface. Which set is the...
- Question #91
Which dial plan function is used to restrict calls that are made by a lobby phone to internal extensions only?
- Question #92
Which type of dial plan implements destinations by using a format that is similar to email addresses?
- Question #93
What is the difference between policing and shaping?
- Question #94
What are four features of Cisco Unified Border Element? (Choose four).
- Question #95
Where do you configure the region for a group of devices?
- Question #96
Which statement about a partition is true?
- Question #97
In a multisite deployment, which two voice codecs are recommended to use between intrasite endpoints? (Choose two)
- Question #98
What are the characteristics of a Cisco Unified Communications Manager group?
- Question #99
Which three types of devices can you test with the Cisco Unified Communications Manager Dialed Number Analyzer tool? (Choose three)
- Question #100
What is a VoIP dial peer?