Cisco
210-065 · Question #86
210-065 Question #86: Real Exam Question with Answer & Explanation
The correct answer is B: There is an error with compact flash.. During the Cisco TelePresence System 1300 Series boot sequence, each numbered step maps to a specific hardware or software check, and a red X on Step 6 specifically indicates a compact flash error.
Question
A Cisco TelePresence System 1300 Series endpoint is in the process of booting and the engineer notices a red "X" on the screen for Step 6 in the boot process. What does this red "X" indicate?
Options
- AThe endpoint failed to load its firmware.
- BThere is an error with compact flash.
- CThe endpoint could not obtain an IP address via DHCP.
- DThe touch panel is malfunctioning.
Explanation
During the Cisco TelePresence System 1300 Series boot sequence, each numbered step maps to a specific hardware or software check, and a red X on Step 6 specifically indicates a compact flash error.
Common mistakes.
- A. Firmware loading failures occur at a different step in the boot sequence, not Step 6 which is reserved for compact flash verification.
- C. DHCP and IP address acquisition occur later in the boot process after hardware components including storage are verified, and would appear at a different step.
- D. Touch panel initialization is a separate boot step and is not associated with Step 6 in the 1300 Series boot sequence.
Concept tested. Cisco TelePresence 1300 Series boot sequence diagnostics
Community Discussion
No community discussion yet for this question.