200-601 Exam Questions

Which describes a best practice rule for controlling traffic between the corporate network and the controls network?

Which statement is true regarding ProfiSAFE?

Refer to the exhibit. L3SW1 has a spanning-tree priority of 8192 set on VLANs 1, 300, and 301, and these VLANs are configured on and trunked between all switches. Executing the com...

Which two are possible solutions to control which devices can communicate between industrial zones? (Choose two)

Refer to the exhibit. Which three options are needed to configure NAT on router GW so PC1 and PC2 will be able to ping 203.0.113.1? (Choose three)

Which selection is a reason why IGMP snooping should be configured on a switched network?

Refer to the exhibit. An expansion project added an E-Tap and Device Level Ring to interface FastEthernet1/1 of L2SW1. The administrator has looked at the logs of L2SW1 and found t...

Which in-depth approach is used when deploying defense in an industrial zone?

Which statement is correct regarding Media Redundancy Protocol (MRP) in a ring of ProfiNET devices?

Refer to the exhibit. What issue does this topology present for the represented traffic flow?

A ProfiNET management system operator is unable to add a ProfiNET Conformance Class B device to a SIMATIC management station. The device is connected to interface FastEthernet1/3....

A cookie cutter machine requires 2 standard controllers and a safety controller. All of these controllers and machine level I/O have been placed on VLAN 104. The safety controller...

Profinet has been disabled on a Cisco Industrial Ethernet switch, which CLI commands correctly enable ProfiNET on VLAN 10?

After commissioning several Stratix 5700 switches in a ring topology, you want to verify the installation against the network logical design. Specifically, you want to verify where...

Which in-depth approach is used when deploying defense in an industrial zone?

How are I/O timeout and Safety I/O timeout calculated?

Refer to the exhibit. CCNA.com has the industrial network shown in the exhibit. All switches are configured as layer 2 switches and are using VLAN 1 as their management VLAN. Each...

Refer to the exhibit. Host 3 on Network A is sending data to Host 8 on Network B. Which address is the default gateway of Host 3?

What are the two most relevant factors in determining the class of administration that is required to maintain the telecommunications infrastructure? (Choose two.)

Which two ports does EtherNet/IP use to communicate? (Choose two.)

Which of the following correctly pairs the dotted decimal subnet mask with the correct number of binary bits that represent the subnet mask?

Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)

You are a called upon to troubleshoot connectivity problems to a network device on a production floor. You have used ping and traceroute to verify that you cannot connect to the de...

Which prompt is used to configure parameters for the Ethernet ports of an industrial switch?

What are two benefits of a star network topology? (Choose two.)

What is the purpose of Spanning Tree Protocol?

A small manufacturing company has a Class C network address on the plant floor and needs to create five subnets, each accommodating 25 endpoints. Which subnet mask needs to be conf...

Refer to the exhibit. Which port should a PLC with IP address 192.168.3.65 be plugged into in order to communicate to the rest of the network?

Which option allows an EtherNet/IP I/O device to be safely installed where it is subject to water immersion?

Which three of the following components must be elected before the Spanning Tree Protocol can converge in a switched LAN? (Choose three.)

EtherNet/IP is an Ethernet implementation of which protocol?

Which two statements are correct for a safe wiring installation to the terminal block of the switch or endpoint? (Choose two.)

Given a ring topology, which loop prevention mechanism provides the fastest reconvergence time after a link failure?

Why is SSH preferred over Telnet as a method of accessing a network device to alter or view the configuration?