Cisco
200-301 · Question #906
Refer to the exhibit. The network engineer is configuring router R2 as a replacement router on the network. After the initial configuration is applied, it is determined that R2 failed to show R1 as a
The correct answer is C. R2(config)#interface g0/0/0. For OSPF the hello and dead timers must match to become neighbors. R1 is configured with a dead time of 40 seconds, while R2 is set to 45 seconds.
Submitted by packet_pusher· Mar 5, 2026IP Connectivity
Question
Refer to the exhibit. The network engineer is configuring router R2 as a replacement router on the network. After the initial configuration is applied, it is determined that R2 failed to show R1 as a neighbor. Which configuration must be applied to R2 to complete the OSPF configuration and enable it to establish the neighbor relationship with R1?
Exhibits
Options
- AR2(config)#router ospf 1
- BR2(config)#interface g0/0/0
- CR2(config)#interface g0/0/0
- DR2(config)#router ospf 1
How the community answered
(37 responses)- A3% (1)
- B5% (2)
- C78% (29)
- D14% (5)
Explanation
For OSPF the hello and dead timers must match to become neighbors. R1 is configured with a dead time of 40 seconds, while R2 is set to 45 seconds.
Topics
#OSPF#neighbor adjacency#routing protocol configuration#interface OSPF
Community Discussion
No community discussion yet for this question.