200-150 Exam Questions

Which three layers of the OSI model are included in the application layer of the TCP/IP model? (Choose three.)

A customer wants to connect to their SAN via Fibre Channel. Which two devices can be used to provide connectivity? (Choose two.)

Which two statements about configuring VLANs on the Cisco Nexus 7000 platform are true? (Choose two.)

What two actions can be taken to enable inter-VLAN communications in the data center? (Choose two.)

An engineer created three VSANs on the Cisco MDS switch. VSAN 100 is allocated to the marketing department, VSAN 110 is allocated to the research department, and VSAN 120 is alloca...

When command set will create an access control 1st on a Cisco Nexus switch to permit only unencrypted Web traffic from any source to destination host 10.10.1.110?

Which type of media uses electromagnetic waves that are generated by lasers, is often used in campus backbones, and is capable of transmitting to a distance of 60 kilometers?

Which two terms can take the place of the wildcard mask in an ACL?

Refer to the exhibit. Two Layer 2 Cisco Nexus switches are connected to application servers in a data center. Server A cannot communicate with servers that are in VLANs 3 and 4, bu...

Which option describes what a switch does after it items that a host has connected to a switch port?

A network design team has decided to use a standard protocol to consolidate the Ethernet and San data using the existing Nexus switches. Which I/O technology can satisfy this need?

What are two physical components of the Cisco UCS B-Series server? (Choose two.)

A network engineer wants to apply for new license key file. Which command should be used to obtain the switch serial number?

Which two features must be licensed on a Cisco Nexus 7000 Switch? (Choose two)

What native Fibre Channel technology facilitates connecting multiple Fibre devices behind a single FC address?

An engineer implemented a new VSAN and examined the F-mode trunks connecting an upstream switch. The engineer noticed that the new VSAN is stuck in initializing. Which two options...

Which two options are multicast addresses? (Choose two.)

Which two options are file-based storage protocols? (Choose two.)

A SAN administrator recently added a new zone to the VSAN 2 zone set named zone set2, but the server is still unable to access the shared storage. Which command will resolve this i...

Refer to the exhibit. What type of network communication is depicted?

What is the maximum distance that is supported by Cisco passive Twinax cables?

What two technologies can be used to connect to storage arrays on a converged Ethernet IP network? (Choose two.)

Which situation will cause a switch to flood traffic out all of the ports on the switch?

What layer of the OSI Model provides the logical addressing that routers use for path determination?

What are three features of the IPv6 protocol? (Choose three.)

Which table in a switch must be populated with forwarding information as to reduce Layer 2 flooding in the network?

A network engineer proposes that old hubs be replaced by new Layer 2 switches in the company network. Which three are reasons for this proposal? (Choose three.)

To improve security, a network engineer needs to configure an access list on a router. In which mode can this list be configured?

What is the minimum number of disks that are needed in RAID 1?

What is the minimum number of fabric modules that should be installed in the Cisco Ne*js 7000 chassis for N 1 redundancy using Ml-Series line card?

Which address and subnet combination is valid for a host assignment?

Refer to the exhibit. What two conclusions can be mode based upon the output? (Choose two.)

A customer requires two separate physical pathways between multiple initiators and multiple targets. Which technology meets this requirement on a single Cisco MDS9148 switch?

Which device does a network engineer use to break the network environment into smaller collision domains?

An engineer must copy a new configuration to a Cisco Nexus 7010 Switch from a TFTP server. Which two commands should be used to retain the configuration after a reboot? (Choose two...

At which layer of the OSI Model is TCP traffic encapsulated?

Which two hosts are part of subnet 172.16.160.0/20? (Choose two.)

Which command should be used to determine which hosts are Fibre Channel targets?

Which two options are benefits of deploying FCoE beyond the access layer?

Which command set creates an access control list on a Cisco Nexus switch to deny only FTP traffic from any source to destination host 10.10.10.10?

An administrator connected a new server to a Cisco MDS 9222i on Port FCL/20, but did not capture the world wide node name of the host bus adapter Which command returns the needed i...

At which layer of the OSI Model is TCP traffic encapsulated?

Which statement is true regarding FIP in FCoE enabled Storage Area Networks?.

A network engineer is verifying Layer 2 connectivity of a server to a Cisco Nexus switch by checking the Address Resolution table statistics. Which command shows the MAC address, p...

Which address type is used in IPv4 but is not used in IPv6?

A network uses on pair of Layer 3 switches for core and distribution purposes. Which design is this network using?

What describes how the 802.1Q protocol lactates the transmission of multiple Layer 2 networks on a single link?

Which address is valid in the data link layer of the OSI reference model?

Which two statements describe characteristics of IPv6 unicast addressing? (Choose two.)

The network administrator has been asked to give reasons for moving from IPv4 to IPv6. What are two valid reasons for adopting IPv6 over IPv4? (Choose two.)