1Z0-489 Exam Questions

Which component is a building block of physical domains (PDomainsorPDoms)?

Which three virtualization options or technologies are included in the SPARC M5-32 server?

You are connection serial and network cables to two SPs located at the front of the server. Your customer has requested that you set this up to enable 1-GbE network speeds. Which a...

You are at a customer site to install some new PCIe cards into their SPARC M5-32 platform. You want to ensure there are no existing issues on the platform before you begin your wor...

In order for ASR to work on the system, what must the customer have configured?

Which three components require IP addresses when you configure the SP network?

Which three statements are correct about installing DIMMS?

Which three statements are correct about the front control panel and rear status panel on the SPARC M5-32 server?

Given a SPARC M5-32 server in which each CMU has 2x M5 processors, each processor has 2x memory controllers, and each memory controller can have 2x BoB, how many memory modules/ se...

A PCIe data path originates from a root complex (from the CPU) on a CMU that connects to a PCIE_SWITCH (in an IOB). Which two components is the signal fanned out to?

Which two statements are correct regarding the power and cooling requirements of a SPARC M5- 32 server?

Which three options are architectural features that you find in the SPARC M5-32 processor?

Use of the Enterprise Installation Standards (EIS) methodology provides a way to _________

Assuming that HOST2 is composed of only DCU2, which two targets report the type of CPUs that belong to this DCU?

You are ready to run SunVTS. Which two commands can you use?

Which statement is true regarding the SPARC M5-32 server SP (service processor) and SPP (service processor proxies)? Each SPARC M5-32 server has_____

Which statement is true about LDom functions and features?

When booting up a pre-installed domain, you are asked for some configuration information. Where should you look for that information?

Which three statements are true about the SPARC M5-32 server power grid connection?

In order to cool SPARC M5-32 servers properly, it is necessary to ensure adequate airflow. Which three statements are correct?

Which statement is correct?

There are 16x CMUs and 4x IOUs with up to 4x DCUs in a fully configured SPARC M5-32 server. The core interconnect component is Scalability Switch Board (SSB). How many SSBs can the...

You opened a console into PDom2 and you now want to get back to the SP. would you use?

A customer wants two DCUs in physical domain 0. What property must be set to true for this host for you to be able to configure this?

A "cold" system is placed into a computer center (cooling air/normally approximately 20?C168" F). With power on, the chip/layer temperature rapidly becomes close to room temperatur...

You are unable to add an Oracle ILOM user account. Which option represents a possible reason for this?

Which three statements are correct about the front and rear panels on SPARC M5-32 servers?

Your customer is asking you the reason for using the EIS methodology to manage their installation. Which statement is true regarding using the Installation Configuration Plan as pa...

You need to run a snapshot to collect SP data. Which two options you can dump the snapshot to?

Before performing a firmware upgrade, you must first check the keyswitch property for each host. What must it be set to for the firmware upgrade to work?

A customer wants you to create a user account for a night-shift employee to be able to monitor the system but do nothing else. Which privilege do you assign to this user?

Which three statements are correct descriptions of SPARC M5-32 server design? (DCU = Domain Configuration Unit, CMU = CPU Memory Board Unit, IOU = I/O Switch Board)

If you have a PDomain with expandable= false, which components will not be tested when the PDom goes through POST?

You have completed an OS installation in a PDom and, after subsequent reboots, you observe an error message regarding the pseudo- cdrom. Which command do you use to clear it?

There are a total of 36 fan modules in the SPARC M5-32 server, and all are redundant and hot- swappable. Which statement is correct?

You have powered-on HOST2 and want to verify its current status. Which two commands would give that output?

You run the following command: -> sec /HOSTO/bootmode script="setenv auto-boot? False" You notice on subsequent resets that Solaris boots in the domain. What are three possible rea...

Which two statements are true according to Enterprise Installation Stan (EIS) regarding boot disk layout?

You have just closed a deal with a customer and are now ready to move into the installation phase of me sales and delivery cycle. For which two reasons is using the Enterprise Inst...

You want Domain 3 to stop at the OBP when you power it on so that you can create OBP aliases. Which two ILOM commands will ensure this?

After completing an installation, you need to collect the system's configuration. Which two actions do you perform?

What are three genera, guidelines for creating the ZFS root pool?

Email alert notifications have stopped working. Which two targets should be checked to confirm that email alert configuration has been set up correctly?

Before running a snapshot you want to check the snapshot settings. Which command would you run?

Your customer is asking you the reason for using the EIS methodology to manage their installation. Which statement is true regarding using the Installation Configuration Plan as pa...

You power -on PDomain0 and notice that it does not go through POST, Examine the following output: In order for this to go through post, which property needs to be changed?

Before turning the system over to a customer, you want to verify that both SPs are functional. Which action do you perform to test the failover?

Using the SP ILOM commands to list properties, which command would you use to find out the mapping for all CMU boards in physical Domain 1 to the CPUs?

You need to record a system's serial number. What command do you run to see it?

The service processor collects audit and event records. The records can be used to show when certain actions occurred on the SPARC M5-32 platform. Which two commands list the event...