nerdexam
F5

101 · Question #616

BIG-IP Administrator runs the command ITconfig from the BIG-IP command the line end sees a high number of collisions. What is the likely cause?

The correct answer is D. Spanning Tree Protocols biochang the con. High collision counts on a modern switched BIG-IP interface most often indicate a Spanning Tree Protocol instability or loop creating broadcast storms rather than a physical or addressing issue.

Section 1: OSI Model, Network, and Application Delivery Basics

Question

BIG-IP Administrator runs the command ITconfig from the BIG-IP command the line end sees a high number of collisions. What is the likely cause?

Options

  • AThere is a duplicate IP address on the network
  • BA crossover cable has been used
  • CThe interface is set to hall duplex
  • DSpanning Tree Protocols biochang the con

How the community answered

(40 responses)
  • A
    5% (2)
  • B
    3% (1)
  • C
    8% (3)
  • D
    85% (34)

Why each option

High collision counts on a modern switched BIG-IP interface most often indicate a Spanning Tree Protocol instability or loop creating broadcast storms rather than a physical or addressing issue.

AThere is a duplicate IP address on the network

A duplicate IP address produces ARP conflicts and intermittent connectivity failures at Layer 3 but does not directly increment interface-level collision counters.

BA crossover cable has been used

A crossover cable on a port with Auto-MDIX support causes no issue, and even without Auto-MDIX it results in a link-down state rather than high collisions.

CThe interface is set to hall duplex

A half-duplex interface setting can produce CSMA/CD collisions, but in a switched environment this generates far fewer collisions than an STP-induced broadcast storm flooding the segment.

DSpanning Tree Protocols biochang the conCorrect

A Spanning Tree Protocol misconfiguration or topology change can create Layer 2 loops that generate broadcast storms, flooding interfaces and producing abnormally high collision counters visible in interface statistics. On a properly configured switched network, collision counts should be near zero, so an elevated count points to an STP-driven loop condition as the primary suspect.

Concept tested: STP loop causing high collision counts on BIG-IP interface

Source: https://my.f5.com/manage/s/article/K8122

Topics

#collisions#duplex mismatch#network troubleshooting#ifconfig

Community Discussion

No community discussion yet for this question.

Full 101 Practice