nerdexam
CompTIA

SY0-301 · Question #329

The IT department has installed new wireless access points but discovers that the signal extends far into the parking lot. Which of the following actions should be taken to correct this?

The correct answer is D. Lower the power for office coverage only. Reducing the transmit power of access points is the direct technical solution to limit signal coverage to only the intended indoor area and prevent it from reaching the parking lot.

Security architecture

Question

The IT department has installed new wireless access points but discovers that the signal extends far into the parking lot. Which of the following actions should be taken to correct this?

Options

  • ADisable the SSID broadcasting
  • BConfigure the access points so that MAC filtering is not used
  • CImplement WEP encryption on the access points
  • DLower the power for office coverage only

How the community answered

(52 responses)
  • A
    10% (5)
  • B
    6% (3)
  • C
    2% (1)
  • D
    83% (43)

Why each option

Reducing the transmit power of access points is the direct technical solution to limit signal coverage to only the intended indoor area and prevent it from reaching the parking lot.

ADisable the SSID broadcasting

Disabling SSID broadcasting hides the network name from casual discovery but does not reduce the physical radio frequency signal range, so the RF signal still reaches the parking lot and remains detectable.

BConfigure the access points so that MAC filtering is not used

Removing MAC filtering would weaken rather than improve security and has no effect on signal range or coverage area.

CImplement WEP encryption on the access points

Implementing WEP encryption addresses data confidentiality in transit but does not reduce signal range; additionally, WEP is a deprecated and cryptographically broken protocol that should not be used.

DLower the power for office coverage onlyCorrect

Wireless access points allow administrators to adjust transmit power levels, which directly controls how far the radio frequency signal propagates. Lowering power to cover only office areas eliminates excess signal in the parking lot, reducing the wireless attack surface accessible to external threat actors. This is the recommended practice in wireless site surveys and physical RF security hardening.

Concept tested: Wireless access point power adjustment to limit signal range

Source: https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan/67073-roam-power-level.html

Topics

#wireless security#RF power levels#access point configuration#signal containment

Community Discussion

No community discussion yet for this question.

Full SY0-301 Practice