A host attached to ethernet1/3 cannot access the internet. The default gateway is attached to ethernet1/4. After troubleshooting. It is determined that traffic cannot pass from the ethernet1/3 to ethe

The correct answer is B. Interface ethernet1/3 is in Layer 2 mode and interface ethernet1/4 is in Layer 3 mode.. Explanation/Reference: In a Layer 2 deployment, the firewall provides switching between two or more interfaces. Each group of interfaces must be assigned to a VLAN object in order for the firewall to switch between them. In a Layer 3 deployment, the firewall routes traffic betwee

Network Interface Configuration

Question

A host attached to ethernet1/3 cannot access the internet. The default gateway is attached to ethernet1/4. After troubleshooting. It is determined that traffic cannot pass from the ethernet1/3 to ethernet1/4. What can be the cause of the problem?

Options

ADHCP has been set to Auto.
BInterface ethernet1/3 is in Layer 2 mode and interface ethernet1/4 is in Layer 3 mode.
CInterface ethernet1/3 and ethernet1/4 are in Virtual Wire Mode.
DDNS has not been properly configured on the firewall

How the community answered

(44 responses)

A
7% (3)
B
77% (34)
C
11% (5)
D
5% (2)

Explanation

Explanation/Reference: In a Layer 2 deployment, the firewall provides switching between two or more interfaces. Each group of interfaces must be assigned to a VLAN object in order for the firewall to switch between them. In a Layer 3 deployment, the firewall routes traffic between ports. An IP address must be assigned to each interface and a virtual router must be defined to route the traffic. Choose this option when routing is required.

Topics

#interface modes#Layer 2#Layer 3#troubleshooting

Community Discussion

No community discussion yet for this question.

Full PSE-PLATFORM Practice