Which two options are required on an M-100 appliance to configure it as a Log Collector? (Choose two)

The correct answer is B. Enter the command request system system-mode logger then enter Y to confirm the change to E. Log in the Panorama CLI of the dedicated Log Collector. Step 1 (E): Access the Command Line Interface (CLI) on the M-100 appliance. When prompted, log in to the appliance. Step 2 (B): Switch from Panorama Mode to Log Collector Mode. 1. To switch to Log Collector mode, enter the following command: request system logger-mode logger 2…

Configure and Deploy

Question

Options

AFrom the Panorama tab of the Panorama GUI select Log Collector mode and then commit
BEnter the command request system system-mode logger then enter Y to confirm the change to
CFrom the Device tab of the Panorama GUI select Log Collector mode and then commit changes.
DEnter the command logger-mode enable the enter Y to confirm the change to Log Collector
ELog in the Panorama CLI of the dedicated Log Collector

How the community answered

(41 responses)

A
7% (3)
B
76% (31)
C
15% (6)
D
2% (1)

Explanation

Step 1 (E): Access the Command Line Interface (CLI) on the M-100 appliance. When prompted, log in to the appliance. Step 2 (B): Switch from Panorama Mode to Log Collector Mode. 1. To switch to Log Collector mode, enter the following command: request system logger-mode logger 2. Enter Yes to confirm the change to Log Collector mode. The appliance will reboot. If you see a CMS Login prompt, press Enter without typing a username or password. When the Panorama login prompt appears, enter the default admin account and the password assigned during initial panorama/set-up-the-m-100-appliance#91340

Topics

#M-100 appliance#log collector mode#Panorama#dedicated log collector

Community Discussion

No community discussion yet for this question.

Full PCNSE7 Practice