Which two statements are true about Transit Gateway Connect peers in anlPv4 BGP configuration'? (Choose two.)

Question

Options

• AThe inside CIDR blocks are used for BGP peering
• BYou cannot use IPv6 addresses
• CYou must specify a /29CIDR block from the 169.254.0.0/16 range
• DYou must configure the second address from the IPv4 range on the device as the BGP IP address

• A
  81% (44)
• B
  6% (3)
• D
  13% (7)

Explanation

For Transit Gateway Connect peers in an IPv4 BGP configuration, the correct statements are: The inside CIDR blocks are used for BGP peering (Option A): In a BGP configuration for Transit Gateway Connect, the inside CIDR blocks, typically within the 169.254.0.0/16 range, are designated for the BGP peering connections. These blocks are reserved for internal network protocols and are commonly used in AWS for automatic IP address assignment within managed networking services. You must specify a /29 CIDR block from the 169.254.0.0/16 range (Option C): It is a requirement to specify a /29 CIDR block within the 169.254.0.0/16 range for setting up the network interfaces that facilitate BGP peering. This specific range allows for the necessary number of IP addresses to establish BGP sessions effectively between the transit gateway and on-premises or other virtual appliances.

No community discussion yet for this question.