Fortinet
NSE7 · Question #94
View the exhibit, which contains a screenshot of some phase-1 settings, and then answer the question below. The VPN is up, and DPD packets are being exchanged between both IPsec gateways; however…
The correct answer is D. The debug output shows phase 1 negotiation only. After that, the administrator must enable the. See the full explanation below for the reasoning.
Question
View the exhibit, which contains a screenshot of some phase-1 settings, and then answer the question below. The VPN is up, and DPD packets are being exchanged between both IPsec gateways; however, traffic cannot pass through the tunnel. To diagnose, the administrator enters these CLI commands:
However, the IKE real time debug does not show any output. Why?
Exhibit
Options
- AThe debug output shows phases 1 and 2 negotiations only. Once the tunnel is up, it does not show
- BThe log-filter setting was set incorrectly. The VPN's traffic does not match this filter.
- CThe debug shows only error messages. If there is no output, then the tunnel is operating normally.
- DThe debug output shows phase 1 negotiation only. After that, the administrator must enable the
How the community answered
(20 responses)- A15% (3)
- B5% (1)
- C10% (2)
- D70% (14)
Community Discussion
No community discussion yet for this question.